Forum Replies Created
-
Posts
-
some are known to leak were the stainless tank top meets the plastic base ( if yours is a plastic base model )
Dave
knew he would be an idiot. its not like you to ignor emails from reasonable people
the way he is telling it is it did not set when normally when that stuff goes off it sets in the tube
Dave
take the sides off and run it
that way if there is a leak you will see it
have you checked for water in the base as when they leak you cant clear thr fault till you remove the water
Dave
I get about 6 different places from one website
the closest is about 80 miles from kilmarnockNord give it as casle douglas not exactly local in our term but scotland maybe 80 miles away is local
Dave
have seen the failure but never went to thr trouble of soldering new components
only problem i can see is the drivers that activate the IGFET’s. if they have been damaged during the failure then it either wont work or go bang again
Dave
next you could check the pump coil is ok
I say this and above as i expect the pump to be the first thing that happens on starting a programme
Dave
site shop is also in Kilmarnock
Unit 5 Bonnyton Industrial Estate
Munro Place
Kilmarnock
KA1 2NPDave
the fault code lights on that unit are the 6 vertical lights (RHS) that tell you where you are in the programme
Dave
Mifa wrote:Thought I’d support a local(ish) business. Bought some oven glass silicone at twice the price than from eBay. Obviously old stock, failed to set after 4 days! No probs, contact them, get it sorted. Well ffs! No telephone, website archaic and advert and glitch ridden, have to register. Success just before I lose the will to live. Wait though, log in not recognised, change password try again, nope, not recognised. Give this lot up as a bunch of clowns. Back to the bay.
how do you know it was local ?
with no address or phone number they could be anywhere. in fact even the phone number does not say anything these days
Dave
pump is clipped onto the side of the sump
find it normally on left side. the pump body twists off but there is a clip that locks it on which can be tricky to find and unlock
once its off check for bits of glass ext that may jam it
Dave
[USER=”125″]don[/USER]
one for youit is also important to get good quality induction pans as there are some junk ones out there
have asked Don to comment as he is our retail guru
Dave
the changeover hose ? DYS916216-02
that shows as still available also hse148 as the pattern part
Dave
