Forum Replies Created
-
Posts
-
ok somewhere on it ( not in pics) is the value in uF and a voltage
will need both to get correct one
Dave
think Tubafan may be right
That cap looks domed at the top
try replacing it and take it from there
Dave
dont think it would be that as i would expect a fault code for that
seem to remeber seeing this before but cant remember why
if you start with the door open, have you tried that to see if “p” comes up
Dave
well we need some clear pics to try and figure it
you will have to host the pics off site and post a public link due to size
Dave
twicknix wrote:
PNC: 911434536
The dishwasher flashes looks like i44 with red light flashing 4 times.
No blockage in filter.
Drain pump activated as if in flood mode.
Am I thinking the pressure sensor being faulty? They do tend to throw up some weird fault if the pressure sensor is malfunctioning.
or blocked pressure switch as its a low signal failure
have you got the rest of the pnc no? there are 6 units under that no
Dave
water pressure goes up and down with use. if other users in the area are using water your supply pressure will drop. see if it makes a difference by using it at odd times
put you finger over the tap to block it, then turn on slowly. if its got really low pressure you will be able to stop it pushing past your finger
the pressure reducing valve only lower the presssure if it exeeds a set value.. if your incomming water is below this value altering it wont change anything
from what i can see the unit should work on pressures down to less then 15 psi and you could stop that with your finger
Dave
