Forum Replies Created
-
Posts
-
its looking for the resistance
you could connect a 40w lamp to the heater wires and see what happens. any lamp should work as long as its not led
Dave
one of the heater problems that can affect the machine is earth faults
check the heater resistance to earth
Dave
https://elementman.co.uk/products/belling-083024000-oven-element
check the sizes as its listed as baby belling but searching by model brings up nothing
Dave
got to be if F hasn’t it as that more like a slow cooker in degrees C
most fridges are set 2 to 5 degrees C
Dave
check board for damage and bad solder joints
check wiring to motor from the board by doing resistance checks from the board connector
Dave
wiring diagram seems to show a capacitor but there is no sign on the parts listing
if its got a start capacitor then thats woth trying
if not its scrap
Dave
use both hoses
use a 3.6 from the machine thern get a 4 inch and use it to extend using duct tape
be aware you will get condensation forming in the hoses so make sure there is no where in the route it can pool
Dave
if you look below the hole the other motor poked through there are 2 holes where the braket on the new motor bolts down
Dave
andyjawa wrote:To what was a 74 quid total Bosch retail insult I have to tell you 2 months ago I threw away a brand new wff instrument panel with soap draw front still in its box since that and half a van load of spares went to the recyclers because no one either knew these parts were up for grabs or as per last time I did this were the slightest bit interested. Seriously, sorry pal had I known!
its always the way , you keep something for years and a week after you get rid of it someone wants one
think what i will do is have an extra large coffin andtake all my stuff with me just in case
Dave
