Forum Replies Created
-
Posts
-
have lost access to tech but from memory the belt needs to be positioned so it misses all the screws on the drum
Dave
well e25 is the code for blockage
have you checked the non return valve on the pump outlet
are you using an over long drain hose or set too high as this can cause problems
Dave
this is not an uknown problem but it is one with no common solution
first off you got a new board but there are 10 machines starting SMV40C30GB and the will most likely have different software but since it has the same problem as the old board then i wouls say it cant be the problem or at best its unlikely
the pump on these machines act as a sensor and the timer measure the work done to determine if its empty. it is possible the pump could be the cause. you could remove it and check for shaft play
but in the end you have to change it to find out if its the cause or not
Dave
set it on the shortest cycle thats not a rinse
when the dispenser opens it should heat
will send what i can find
Dave
why so many engineers its mad
if he though it was a wire why did he not trace it
madness
this is probably down to times. he has so many calls to do so if he runs over he wont finish. so he dumps your job and moves on. have not got that luxury and its unfair on customers. everytime another engineer has to call someone has to wait in and if you work thats not convenient
Dave
should fit
have fitted lots of these and never had one not fit yet
sometimes i have had to use the old metal casing and just fit the coil but works no problems
Dave
difficult to see pic but R2 does not look to clever either
the inportant thing for me is where the pin labelled goes to . I can see the whole board and io cant see the other side so i cant read the connector number. what i need to know is why these resistors blew and then we know if we replace them or the board they wont blow again
Dave
tubafan wrote:I’d have thought the failure of those resistors is more likely to be a consequence of another component failure. Unless you can find that they are likely to burn out again.
agree there we need to find out what these resistors connect to
some early model with old thermistor on the element used to blow to earth and damage resistors
Dave
