Forum Replies Created
-
Posts
-
teresagreen wrote:It’s in a repack bag I’ve been charged £48 for that
most miele gen seals are in the £90’s ish so if you called Miele not only would the labour charge be a lot higher the parts would be too
Dave
you are going deeper than we would as engineers
from the diagram you should be able to work out the trigger wires for the module as a way of testing it
there will be one trigger wire to start and stop motor
the other wires going to the module set speed wash , distribute and spinmost of the time problems like this are the motor control board
Dave
well the most likely fault is the motor board. if you just triggered the triac does not mean board is ok
did you check motor tacho. on some boards motor wont run with open circuit tacho
next is the reversing contacts at the rear of the timer and the contact that activates the module to start and stop motor
if all those are ok then its the module control contacts
Dave
there are 2 sections to the timer
the back cams move all the time, they do things like reverse the motor. and start and stop the motor. that will probably be the lower diagram
then there is the main cam switch which move one click every now and then. that does every thing else . valves. heater pump etc
Dave
your not alone in wanting this but it was not available in 2016 so even less chance now
Dave
just checked site still not working
google searched bring up flooded base but am sure you checked for that
got one hit from a guy that fitted a new fill valve. unit worked ok with old valve ( only swapped because it leaked in) but gave E40 with new valve in. Valve was generic as he could not source original
with that in mind the water turbine would be the place to look
Dave
these semi circular elements always seemed to fail more often
important thing is the fan as anything that slows the fan will over heat element
lastly is element quality I only fit Genuine or at a push Irca made elements
remember fitting a pattern element and watch it blow in 10 minutes. have never fitted one since
Dave
Hollytree_Technical wrote:Yes that looks like the system.
It has got one of these AGM72924807 shock absorbers at the rear but I don’t know if there is supposed to be a damper built into it or not. It also has a similar part (different part no) each side at the front along with a couple of traditional dampers.Jem
there is a damper built into it see pics on Aswo
Dave
