Forum Replies Created
-
Posts
-
well connect are showing me £91
connect pt no 5055005000178
got the part no for the part from aswo. should be DC92-02642N but you would need to double check
as you say it may not be worth it
Dave
well as a long shot you can disconnect as much as you can and see what happens but I think you have a board problem. not unusual on Samsung
the problem is which board
touch display board is £88 on Aswo
2nd board down below at £95 on Aswo
all plus V and p&p
Daveits as if some other tap is fed off your meter but it will only show shen its used. so any test woulds show up as correct volume wise
have you got a main shut off valve for your water inside your property ?
was thinking if you shut that off and take readings before and after. Be even better if you were away for a weekend
Dave
a lot of Miele pumps have a small breather tube system to get rid of suds lock/ air locks
it will be a very small tube coming vertically off the pump and it joins other tubes at the top
had a few blocked causing this sort of problem
Dave
there is no other sensor. they used to use pressure sensor but not now
they measure the current of the motor to determine if its empty or not as when the motor is under load it draws more current
that means its either a motor fault or a board fault
as the motors age the bearings fail. as the bearings fail the motor draws more current as the rotor contacts the casing. This fools the board into thinking that its not empty hence the fault code. it can also be caused by debris jamming the pump rotor
and yes it seems odd it should only fault out at the end
the question you have to anser now is do you want ot gamble £20 to see if you can repair it
Dave
ok its the later system
from info it was built jan 2010
the drain pump acts as a empty detector
fault codes comes up as
Drain pump unable to rotate,
attempts to clear failed.
Check for debris at drain
pump
drain pump is part no 611332youi can get on Amazon for about £20
now i cant promise a cure but its not expensive if it fails
you could try removing the pump and check for debris first
Dave
ok we need to know whats tripping
RCD that detects earth faults ( look for the test button )
MCB that act like a fuse and detects over current faults
or the latest trips that combine both RCBO
Dave
if they are on different circuits they cant affect one another
most of the time a cooker is on its own circuit
Dave
Twoten wrote:
.
Any idea when the water runs through the condenser on this machine?
no but a lot of later machines are not letting water in till it determines if there is steam to condense. water savingDave
