[electrofix]

take the bottom of the door off first

then you can remove the control panel

if you dont take lower door off then the wires would be too tight to work on it

Dave

[electrofix]

wow you have been busy. nothing for weeks then it all comes at once

Dave

[electrofix]

it could be in the pump itself

to check that you would have to remove the pump

Dave

[electrofix]

if the flame is going out it suggests to me that the combustion process is not working properly. you have to have the right ratio of gas and air for the burner to funtion both safely and efficiently

in this case you need a gas safe cooker engineer to call and make sure your not in danger by using this oven

Have you got a carbon monoxide detector in the kitchen?

Dave

[electrofix]

is the motor free to turn or does it feel stiff ?

Dave

[electrofix]

there are 3 gaskets not 2

depends on serial no

clumns are begin and end so gasket 765 begins serial 2036 and end 2137

Dave

[electrofix]

that sounds like an iffy door lock

dont know if the lock only locks on spin or all the time. you would need to ask client if they can open the lid to add stuff after it starts

Dave

[electrofix]

its vestel

aswo is your best bet

you need to decipher the serial no to find the correct part

serial as above is
01745398003552200139.

becomes

10745398 5500355220

Dave

[electrofix]

have you checked pressure system for blockages ?

Dave

[electrofix]

https://www.partadvantage.com/modelproduct/index/view/id/3LWTW4705FW1/WPL

part list is here

assume you have checked the start switch

its got a lid lock like the door locks on front loaders check that

Dave

[electrofix]

have sent you the info to go into service mode

Dave

[electrofix]

they dont give readings for measuring the sensor. they do Say

In mini led washing machines with aquastop, the aquastop circuit is connected to level sensor cable. If the aquastop buoy detects water level for whatsoever reason, it will detect it as machine level sensor error

but that would give you an E7 fault

not mention of 44 and conditioner symbol

have you tried service mode ?

Dave

[electrofix]

cant see that its too small but assuming its the same part no I stated above

does not suprise me, dont use connect much but if they charge me more its not suprising

its mad a company wants my business but is always dearer than my other supplier and expect me to use them

Dave

[electrofix]

module look correct and yes its likely its the fault. may just be an ageing capacitor but that gets into electronics

check with site before you buy as to look up part no you need the serial no on Beko

as for the outer door it all depends if the kitchen fitters are good or not

go round all the screws on the inside of the door. remove each one. if its less than an inch put it back. there should be 4 long screws if its done correctly

after that the outer door should slide down and come off

Dave

[electrofix]

sounds like the main board is failing

they seem to be quite cheap often under £40 for the part

Dave

[Author]

Posts