Forum Replies Created
-
Posts
-
no thats the temp sender
have you checked for broken wires as you sometimes get owi faults when the unit has not got one
have removed your phone no as we are on a public forum and thats not safe
Dave
yes there are certain components that are panasonic but the panel andd sofware within I doubt you will find an alternative part
there is one on ebay but does not have panel so may be a common failure
you could as QER if they have a fix
Daveyou cant miss it. its in the water in the side of the sump bowl
also problem with fault codes is its a guide and not always correct
manual will say Owi fault or control board or wiring. you cant be certain till you swop something
Dave
well Beko is still an ok brand in the lower price range and you get 2 years guarentee
you could look at neff and that includes Bosch and Siemans which are the same company also 2 year guarentee
Smeg are ok not sure on guarentee
failing all that you could look at electrolux which includes Zanussi Aeg and Tricity Bendix again all same machine in different cases not sure of guarentee
Dave
well looking up old fault codes it comes up as the owi detector
that a detector in the sump that is for temp and look at the water contamination
but common fault on old whirlpools is the wires snap at the bottom of the door where it hinges
when you investigate do it carefully as there may be multiple wires of the same colour
Dave
been there kitchen fitters are a pain
been to a dishwasher today for a client. had a new kitchen fitted and they did not connect the water pipe
as for the module its the correct part no
the display module is as you thought just display
Dave
that was ok till you say disconnect and reconnect facia
the main power supply will generate low voltages to power facia board but it could be either
I tend to think display board as disconncting power or disconnecting display board do the same thing and it powers up.
if the main board had failed if you disconnected facia i would not expect it to come back on
but can never say for certain
you could try and find the voltages from the lower board and see if it is still there after failure
but at the end of the day I would quote for both boards and offer to order display first to see if it works. Make it clear they still pay for the whole job and both boards but you can reduce price if it does
as a very long shot disconnect motor and heater and see if anything changes
Dave
listed on ASWO they dont give gen numbers
both Qualtex and Connect dont list
2 boards display board and main pcb both around £70 plus
Dave
both normal
there is always a few cup fulls in the sink and water coming out of softener is nothing to worry about
Dave
first thing to check is motor brushes
think its a brush motor but your model number brings up 8 varients so cant be certain without checking all or getting prod codeDave
panel comes off a treat
carefully take all the screws ouT and ease it off
the only thing to beware of is some of the metal edges can be very sharp
Dave
bet you the tacho coil has gone on the back of the wash motor had a few go
its used to control motor speed but also detects if the motor is running so it can turn on the heater
aeg dont supply so fit Beko 372205506
Dave
