[electrofix]

where is the meter
in the house or in the street?

Dave

[electrofix]

does not look good

Dave

[electrofix]

these firms seem to change names or have multiple names

cant trust any of them

Dave

[electrofix]

its a vented dryer so has to be an airflow problem

this dryer works by pushing the air out of the dryer. this forms a vacuum in the tub and sucks the air in over the element

so you either have.

a blockage in the airflow out

blocked filters ( which i know you have checked )

faulty drum seals. if these are faulty the air gets sucked in instead of going over the element

so you looking for anyway the air can get in circumventing the element

Dave

[electrofix]

i would check to see if the heating element is faulty with a meter

if its open circuit its likely changing it will cure the problem

Dave

[electrofix]

camt be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain but it does seem to fit

Dave

[electrofix]

pity there is only a like button as i need a sad button

Dave

[electrofix]

cant find any info but my first check would be the cooling fan

Dave

[electrofix]

water tubine fault

Dave

[electrofix]

a lot of machines now go into spin on drying cycle.
there must be some energy saving for them to do it

is he stopping the cycle before its finished ? so it does not run cool cycle

Dave

[electrofix]

clockworkone wrote:Quinnspares special order or amazon pld1822. Retailed by Paxanpax so unsure what quality will be like. I just heated up the pliers version and made the tips a bit wider. Getting too sore on the old fingers without them.

Think Panapax is an H T Maddocks trade name

Dave

[electrofix]

ok can be a few things so try this

with no clothes in it

select rinse and spin

watch when it pumps out, you should see the water dropping, slowly at first then quicker
it should then spin

if it works ok could just be an out of balance load

you could check the filter first as a starter

Dave

[electrofix]

you cant lose that much water without some sort of leak. if it was turning into steam you would have a cloud over your house

Dave

[electrofix]

you have to let the board learn when its empty and as micky says you put 2 litres of water in or so

set it to pump out and let it finish

hopefully it will reset the empty point

Dave

[electrofix]

just had to delete 2 similar spam posts

seem to add advice and at the end add an link for an essay writing service

RachelInouye

RamonaYork

Dave

[Author]

Posts