Forum Replies Created
-
Posts
-
none of the major wholesalers list it
you will have to put in part no request with one of them
unless someone on here is an LG agent
Dave
ok when it stops does it come up with and sequence of lights
if not it does sound like a board fault as it cant hold in the relays. you can see the flashes as the heater and motor kick in but it cant hold it
A lot of Hotpoint board can only be fitted by an engineer with programming equipment
Dave
check the resitances of both NTC’s
Door NTC Resistance : 12 kΩ (Measured from IDC connected to electronic card )
Heater NTC Resistance : 19.5 kΩ (Measured from IDC connected to electronic card )normally measured about 20 degrees C
Dave
yes its beko build
welcome to the impossible
outer hinges can be got at. hinges in the middle then you have to remove the whole oven cavity as far as i can see. seen one but never managed to repair it as it would take hours to do
Dave
ok may be able to help
found an old bosch board which wires were cut to remove. one of the plugs is the right size and by cutting off the the locating lugs it goes in and makes a solid connectionthe bad new is one of the leads is only about 15mm long but am sure you could solder and tape it. the other 2 wires are about 3 inches
Dave
its also worth noting that if it was frost free there would be a lot less room for food storage inside
Dave
no cant be the element the way you describe it
element either work or not normally and if it failed in use it would continue with no heat or throw up a fault code
Dave
you cant
no decent engineer would work for that unless they supply van, fuel and insurance
then maybe but if the jobs are miles apart that will make a difference
you cant even make money on spares by the looks of it
Dave
correct a job for a refrigeration engineer and as you say cost wise probably not worth it
you could look into a repair by hoover under the parts guarentee
that way you pay labour but parts are free
Dave
think the plug on the motor side has not changed but cant comment on the other end
it can be a pig to get this plug out at the best of times. I have pulled the odd wire out while trying to extract it. sounds like your customer has been too enthusiastic
Dave
https://www.miele.co.uk/c/spare-parts-and-accessories-24.htm
go here and push button marked “full spare parts catalogue “then enter full model no
Dave
