Forum Replies Created
-
Posts
-
common fault do it all the time. have done 2 in the last 2 weeks
you will get away with it over 95{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time by just replacing the chip and inrush / safety resistor
Dave
its not going to be worth repairing as it will be a compressor failure
even if its a cheaper low gas problem you have to think how has it got out of a sealed system which means leak finding
scrap it
Dave
there are resets for various machines but dont know if it resets customer perameters
I would ring customer service and ask the question first
Dave
bosch are not very helpful in their manuals about this
it does say some programmes cant use I-dos but does not say which or list the programmes
it also says if you select certain things it will remember for all future washes
was wondering if you have set this programme to manual dose and you have to tell it to revert
only guessing really and i would ring Bosch customer service and ask
they do need to improve manuals to include more comprehensive info on these complicated machines
Dave
if you trurned it off while it was running it takes a while to come back on as it needs to cool down
if the compressor is hot later on and its not freezing then we may have a serious problem
Dave
to control the fridge temp there will normally be a motorised flap controlled by a temp sensor
first off as always in these cases, make sure all the board you had repaired connecters are sucure and in the correct place
Dave
yes it means it cant get cold enough to trip off the stat
will pay you to change it as its got inefficient
Dave
Had customers have a problem machine and vow never to buy again only go out and purchase the same machine with a different name on the front
Dave
1 in warm weather expect the compressor to run a lot more
2 not sure how old this is but as systems get older and wear the efficiency goes down. this could mean it does not get as cold as it should and you may have ice on the back wall but unless the area of the evaporator where the thermostat probe sits get cold enough to turn it off it just continues till a huge lump of ice forms on the rear wall
are you getting a large lump of ice ?
Dave
