Forum Replies Created
-
Posts
-
Re: Ariston A1400SWD – Pulsing on fill and overfilling
Brushes ? really ? I’ve never seen that before but how to superior experience and knowledge.
Pop back and let you know what I find – thanks muchly.
Re: AEG favorit 88010v1 DISHWASHER – NO DISPLAY
Hi Martin, no its definetly a 88010v1 mate.
Looking at the drawing above it seems this has a second board in the machine and not just the one in the door as I presumed. Is this a power board do you think ?
cheers
gadget
Re: Hotpoint WMS38 not taking conditioner.
Thanks for the input – yes there are 4 inlets to the dispenser and one is blocked off and from the above drawing they are connected correctly – does anyone know the test sequence for these machines – they have a dial selector and start button rather than an on/off and start as suggested in the test sequence posted on here.
cheers
gadget
Re: Hotpoint WMS38 not taking conditioner.
Yep everything is fine – from memory machine is level vertically but does seem to be unlevel left to right – right side being lowest.
Can anyone tell me how the 3 pipes from solenoids should be connected – ie two cold pipes on dispenser inlet 1 and 2 etc.cheers
Re: Hotpoint WMS38 not taking conditioner.
Yes tested valves with meter and measured voltages when being activated so I know they work and appear to work in correct order – no blockage in syphon – but no water seems to be going into the conditioner/prewash side – left as you look at it.
gadget
Re: SERVIS M6815W
Ho, thanks for the reply – how do I check the motor – never tried to fault find one with a toc before – cheers.
Re: Brittania SI-9TF-SS Thermostat
Yes I have spoken to Brittania already – but £80 for a stat is ridiculous – looking for an alternative please.
Re: Hotpoint WMA60 Fills then drains !
Just thought I would close this off – found broken wire on motor connector block – motor cut out I believe. All fixed.
Re: Hotpoint WMA60 Fills then drains !
Thanks for replies guys, yes could well be a communication problem – customer sounds about 90 !! two years older than me haha.
Jim: Would appreciate the test routine please.
gadget
Re: De Dietrich DOD338XU11
Hi, thanks for that. Yes popped back today and stripped this out – the wax actuator works as I tested it out of the lock assembly. If I actuate the lock myself still nothing works – if I set the oven to pyro I would expect the lock to close and the lock led to light but it does not – the oven light does go out though ! There must be a way to bypass this lock at the board – does anyone know how ?7
Cheers again.
Re: Manufacturer No 2 looking for agents
Hi Ian, sounds like this is a long shot but here goes anyway :
Postcodes – ST15 – ST21
All WS postcodes
All WV postcodes
All TF postcodes
B72 – B76All laundry, only electric cooking, no gas or systems.
AMG Electrical
Mitch Pendry
01785 710807/07940 318318
mitch@amg-electrical.co.ukCheers
Mitch
Re: LG WM1285FHD – DRUM NOT TURNING
Yes I have been doing some digging and realised there should be a code – customer thinks it showed LE but not sure.
gadgetdad
Re: MRK Domestics Birmingham.
I work that area but have not heard of them – googled them and came up with this number 0121-475-3305
gadget
