Forum Replies Created
-
Posts
-
Re: H/point d/washer.start b/ton/selector for pcb, no part n
Hi
Try C00087953 – check out on connect etc to see if this is what you are looking for
Geoff
Re: Hotpoint EW74k
Hi
That you for the information.
I think the part number for the ring should be C00230445 as connect showing a plastic trim on c00230455
Geoff
Re: Beko WMA510 Inner drum
Thank you very much for your replies plus the information
Lots like the job will not be too bad – he says hopefuly
Geoff
Re: CREDA T622CW
It May be worth checking the capacitor for the motor. If it is starting to weaken it will fail to start the motor hence no air flow and cut outs blow.
Geoff
Re: Hotpoint WMF40p
Thank you
Yes it is a 540 – fingers to cold to type properly.
Funny that it only does it on this programme
Geoff
Re: Hotpoint WD61P
Ha
I might as well taken Basil with me as it turned out to be the shaft on the drying timer knob split.
Cable tie later and he is back on the go until I get a new one posted out.
Geoff
Re: Zanussi WJS1265W,motor not turning,Diagnostic error code
Hi
This fault code can sometimes come up due to the motor having low resistance to earth.
Can your local guy meggar between the motor pins and the chassis of the motor?
Power off before undertaking any work
Good luck
Geoff
Re: Zanussi FLS1383 doesn’t spin,
If what the spin doctor suggests does not cure then I would suggest that it could be the module fitted to the lower rear rh side of cabinet. (looking from front)
I have had several of these causing no spin and stopping the timer from advancing.
Geoff
Re: DeLonghi DFS901SS
Hi
Is the door sealing?? If it is there is not much that can be done as there is no adjustments on these doors
When shutting the door does it touch the seal at the top then open up a gap between door and seal?? If it is doing this then remove the door and check the rollers within the oven door hinge receiver. This roller should not be able to move up and down. They have a habit of wearing and not holding the door firmly closed. rplace these and door will close firmly.
Geoff
Re: hotpoint ff187m
hI
With this unit the internal light flashes after the door has been opened for more than 2 mins.
Check that the light switch is being activated by running a magnet along control panel to see if light goes out. there should be a reed switch built into control panel and a magnet into door.Hope this helps
Geoff
Re: Hotpoint WD61P
Ah
That you for that – got it safe and sound.
See what you mean about one shot cutting off neutral feed.
Will go armed with manuel and TOC
Again many thanks
Geoff
