Forum Replies Created
-
Posts
-
Re: Hotpoint FDW20P
Well he does want it done.
S/n 71102-2909 37331821000
Is that enough info for correct pcb?Re: HEC Spare
Thanks guys. Rang customer with details and the imortal words of ‘bought a new one now’ was their response.
Re: Plaset COD63096 drain pump
This any good?
http://www.it-galina.de/index.php?main_ … &cPath=1_9Re: Bosch Maxx WFL2260 – Poor quality wash
Insufficient rinse or overload sounds favorite. Has this problem just started and machine o.k. before ? If it was good then what is she doing different now?
Re: Bra wire nightmare
I have had situations in the past, irrelevant what make of machine, where something has got caught between the front of the drum and the tank. With the customers permission I have levered away the front of the drum just wide enough to release the object (key, jewelry etc.) and then pushed the front of the drum back into place and planishing out as much as you can. The most damage I have left is a minor crease that has no functional nor cosmetic problems. I use a large, flat bladed screwdriver. Looks a bit barbaric but surprising how you can ‘make good’, afterwards and you don’t have to remove the machine. Try it on a ‘write off’ first if it sounds a bit daunting,
Good luck,Re: Hoover HNV 380 Tumble dryer. Quick!
Thanks but if it is the capacitor, why does the drum rotate[under load] at all?
Re: Diplomat Washer Dryer
This is a Sevis variant and I’ve found that 9 times out of 10 it’s the board.
Could always check the multiblocks for a poor connection due to vibration but doubt it. Check the board visually, sometimes find an obvious burn point. Expensive too.Re: Miele W864
What?
Thanks mate I like the occasional challenge (not sure about this one )
I’ll let you know tomoz.Re: Miele W864
Guessed it was brushes or so because of its age. Thanks, just wanted confirmation, it’s quite a way out of my patch but needs must.
Guessing again the carbons arn’t going to be a ‘one off’. Just a cartidge I imagine.
