[helo_75]

interestingly, for the indesit with the board at the top, u will need the original hardware key, because youll need the adapter and cable to plug the smart card reader into

the plot thickens

[helo_75]

something in the pump?

[helo_75]

been well documented

http://www.ukwhitegoods.co.uk/modules.p … ic&t=31877

the new link you need to use is

https://www.bosch-eshop.com/eshop(bD1lbiZjPTAwOQ==)/bosch/gb/indexa.htm

[helo_75]

emabarrassing

the clock is ticking…………

[helo_75]

ok, lights in order ( excluding on off) 1- 5

what are the order of lights, ie 1 and 4 , 2 and 3 etc

then we can help you

[helo_75]

and pallets of em in the back, ready to go back……….

[helo_75]

oh dear so scolaris been confirmed as chelski manager eh, starting july 1st

wonder if it will affect portugals chances, and more to the point why wouldnt he be englands manager if he hates the english press so much?

may abramovich’s wallett is just too big to ignore?

[helo_75]

nah, quite simple, plug in the reader, insert card, wait 5 minutes, take card out, done

no danger of putting eprom in wrong, or even the wrong eprom

[helo_75]

check if the door actually locks?

if it does and it doesnt start, check the brushes

usual hotpoint tat to be honest

may well just be the lock

[helo_75]

the same on you use for all the wf/wt machines

its the same pcb, effectively

but your right… the stuffs rubbish, all the same

[helo_75]

but the fluff insdide isnt metal

dont you do a lot of ctd/vtd dryers?

[helo_75]

should be

[helo_75]

interestingly, if its programmed, and you could take the info off the board, you could fit as new board and reprogram it

what do you use?

[helo_75]

well, it will be.. for earlier models certainly
since indesit are phasing the pcb and eprom out, all that will be available by the end of the year are the board and the smartcard

now, hotpoint can still use their hardware key, and program the pcb without using a smart card.. though as usual, not available to anyone other than their own service engineers

so if someones got some decent software, they could, at a pinch take the source code of each card, and use it to program each pcb, after all, its only the fact that the board comes with a blank eprom installed, its just the independants who suffer

so yes, in answer to the initial question.. its worth buying a smartcard reader, i mean, how many customers are willing to spend on one just to repair it the once?

better for the independants if you ask me

has anyone spoke to emw about the new system? im sure with the right software, nothing changes for them

[helo_75]

i am nice

most of the time

[Author]

Posts