[helo_75]

all isnt lost

there are some parts available

http://cgi.ebay.co.uk/Hoover-Twin-Tub-M … 20ad9bd8fc

http://cgi.ebay.co.uk/Hoover-Twin-Tub-W … 1e5a68c4ae

will cure the droning on the wash side

your problem is with the spinner

it could be lubricated, but as to the butterfly valve in the pump, i just dunno if anyone might have one lying around?

[helo_75]

it is just a normal pulley bolt.

locking the drum in postion and using a spanner seems the right way

however, i use a big pair of mole grips and give it a whack, to loosen it off

but be careful, its easy to hurt yourself doing this, and suitable safety precautions should be taken

[helo_75]

noisy as in?

i.e is it rumbly or clicky

could well be a shot motor

[helo_75]

no clips needed

twist it off and refit using same method!

trust me, ive fitted loads, and get some practice, theyre going down faster than portsmouth!

[helo_75]

2 different types, depending on serial number

error 7 is.. (again depending on variant)

Jammed Motor’s Rotor and/or Wiring

OR

Defective Door Safety Lock Device (blocked closed) and/or Wiring

its worth checking the motor

[helo_75]

comet have them in stock, but be warned. we’re less than useless, according to some on here

[helo_75]

thats a decision u gotta take.. 9/10 times its the pcb

worth chekin the pcb connections 1st

[helo_75]

not sensing pressure switch

could be pressure switch, more likely pcb at that age

good luck, the pcbs are a lot of money

[helo_75]

theres a memo…..

heaters a problem for some, not all#

[helo_75]

theres a rubber ‘o’ ring that lips over the end of the valve, and holds it all in place

you can buy the part, but your better with a complete valve , to be sure its right

[helo_75]

Re: Comet Service & Customer Aftercare

in fact, no, ive deleted it, your not worth the finger work

[helo_75]

oh i love these machines

can u be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure the pressure switch has deactivated?

[helo_75]

heater relay fault me thinks

new board required

[helo_75]

Re: Comet Service & Customer Aftercare

squadman wrote:
Really ? Unless you are involved in this particular job how would you know if its correct or not ?

Connect have stock of all the parts to complete the repair, Comet do not and according to Comet Service their suppliers do not have stock and that is what Comet have told the customer.

.

no, and neither are you, but you seem to know ‘ its correct’…ur just goin off what someone has told you, and im saying its probably not as bad as its been portrayed

[helo_75]

not likeley to be wholey accurate im afraid

i work there remember, and i think thats been made to look a whole lot worse than it is/was

jobs dont dissapear, theres guidelines and rules.. customers pay little attention then kick off when they dont hear what they want to.

im not gonna start an argument. itll drag on and on, and get messy

i know what you posted is incorrect.

[Author]

Posts