Forum Replies Created
-
Posts
-
error 2
The Water Fill Phase was not completed within the designed limit time. Defective
Solenoid Valve, Pressostat, Water Fill Hose, Low Water Pressure in the network
and/or Wiring.so take yer pick, from no water, syphoning to duff board
try using the commercial code, take the 37 off, 30382
im right, c00144256 sopercedes c0066602 on servicenet anyway
its always worth checking the drain function.. i e empty the filter and check the hoses for obstructions
if theres motor action, and the drain function is good, it will more than likely need a new pcb.. ive changed a few for that fault
you could try changing the door lock, that will do it
open the door, release the spring from around the door seal, peel the seal back, undo the 2 screws on the lock and it should come out
just make sure the plugs out
id hazard a guess that the programs are all out of sync?
what happens exactly, when u put it on say, a spin program?
and a model num would help too
is it a go 292/482/682/1482?
theres a few listed
c00273150 is the only one listed on servicenet…
why do you need a door trim anyway? ive only ever changed them cos they break where the handle fits, and at that i just drill small holes top and bottom of where the handle fits (downwards in the inside) and use self tappers to secure the handle to the trim
never had one come back yet
