Forum Replies Created
-
Posts
-
covers are available
a quick look round the forum will tell you people have the same problem
the best way to clear it if its jammed is to remove the pump rear and clean it out that way, rather than break it off
the pump needs to come off, plain and simple
if you machine hasnt got a sealed base, then , unscrew the kickplate, uncrfew the pump form the machine, and it will be serviceable from underneath
other than that, the front panel will need to come offof course if your happy to wait without a machine while you wait for the filter cover, then smash it off and clean it
but wee need the full gb number to get the right part number for you
hth
i dont say these things for a laugh ya know, i see them from day one remember
just for reference, its worth checking the door lock as well
oops sorry, missed that
one of these is all it will need
take off top and both sides
remove rear bearing pin, then remove the screwas holding the water container to the back panel
take the hoses off, and the back panel should be free (ish)
after undoing the metal side bar, you can egt the drum out by pulling the back away, the drum will come out of the side
take the fan cover off, and feed the new belt over the fan and slip it onto the motor shaft
slide the belt over the drum, and place the drum back, making sure the belt goes over the pulley, this makes it easier
not a nice job.. did one today, and im still bleeding
id advise some good gloves, the panels are incredibly sharp
oh, and be sure the plug is out
and cos its a ctd80. u may need to unfasten the pcb and let it dangle, or the drum wont pull out
its on the neutral… follow the wire from the terminal block up, and ull see it , half way up, theres a metal bracket holding it on place, and is covered with a red sheath
easy fix matey
id still try tightening the wieghts, even if theyre on…
if the bearings havent gone, the weights either loose, or one of the suspension legs is broken, or the dreded drum spider
even if you bought one, you wouldnt be able to programme it without either a card reader and card or a laptop with emitt software
emw will supply the right one, plug n play
