Forum Replies Created
-
Posts
-
2 and 4 is f05
which is pressure switch stuck on full
99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time, its a pump blocked, or something in the pipe
check BOTH hoses , the black sump and the grey outlet hose for obstructions, particularly were the sump meets the tub, theres a ball in there were stuff gets stuck
it may well be emptying, but is it fast enough??
hope this helps
hmmm
11 way ?
12 way ?theres a few cables listed.. none specific
oh , and full 16 number serial number would help?
lol
what you want to do is make sure the red comdenser clip is fully locatedquick check to see if the lights on when u open the door…
there will be an obstruction somewhere….
more than likely in the neck of the sump wrapped around that damned eco ball
unfortunately, its a very hard one to get right
personally, id have fitted the modified fan and collett, but not everyones privvy to the help available… lordhelpus was offered assistance, yet refused our offers of help
at the end of it all, lordhelpus is an engineer, a hard job to do in the environment hes in.. customer and employer want the quick fix.. under pressure to perform at little cost.. maybe he felt it was the right option
if he’d joined the trade section, he’d have found a wealth of information, freely given by others in the same situation
whichever way you look at it, everyone has a good point of view, and rightly or wrongly, good advice was ignored
experience is a wonderful thing, as long as others share it with you!
forum rules apply im afraid
all i can say is that on some servis machines, the wire number was written on wire itself, and fits on the corresponding terminal
unfortunately, ive seen this before
it will need a pcb, theres no other problem, and theyre not cheap!!!
your starting to make yourself look like a paranoid delusionist
what do you think admin are going to do? email your employer?
dear xxxx
did you know your employee , lordhelpus is asking a question about a fan on a washer dryer? you should sack him immediatly!
get a grip.. its a quick check to ensure you are trade, and not a nosey member of the public looking for insider info
but thats fine, your not important enough to have any consideration for
your missing out, not me, and sarcasm isnt a route you want to go down, especially not with me
just consider, if your employers are so high profile, why havent you got access to any info at all about a simple hotpoint fan.. the answer to which i gave you very quickly?
so ill carry on bein a ‘happy luv’.. but next time your scratching your head looking at something someone in the trade forum may have a simple answer to, ill be on my next job!!
happy hunting
