[hilly]

Re: hotpoint fdw80 al10 error

does the module for these come ready to fit or do they have to be programmed? ive just been looking on hotpoints site and they list a blank eprom as well as a module

thanks paul

[hilly]

Re: hotpoint fdw80 al10 error

thanks for replies i will let you know the outcome 😉

thanks again paul

[hilly]

Re: hotpoint fdw80 al10 error

any clues? im going back on monday and would like to be armed with as much info as poss. 😉

thanks paul

[hilly]

Re: hotpoint fdw80 al10 error

sparkys wrote:check pump for blockage, also you will find water inside the pump impellor, clear, grease and reseal

thanks for the reply, are you talking about the drain punp or circulation pump?

paul

[hilly]

Re: hotpoint wdl520

maltheviking wrote:How come you got involved with this one Paul? must be under gtee. at 3 months

the machine is owned by the university & the use the machines get on the campus they aint interested in gtee’s they class it as commercial.

all four of the lights flash & the start/pause button, are the error codes on these the same as widl range?

cheers paul

[hilly]

Re: Workware

i use a company called burlaw sports & workware 01482 508750, 07753372741 very competetive, they supply & embroider,

paul

[hilly]

Re: relay supplier

just been out to my van to get model number its a tdc 62 i think the relay on the dryness module is faulty & the customer is going to buy a new machine due to the cost of the module so im curious to see if i can replace it, if i can obtain the same one,

thanks for the replies,
paul

[hilly]

Re: relay supplier

yes sorry, its off a hotpoint condenser dryer,its a era and the numbers i can read on it are : Typ El 30/18, BV 030-8180.0 08/02T
not sure if they are relevent,

hope this helps
cheers paul

[hilly]

Re: ise 2 motor failure????

cheers jim i didnt have the service manual

much appreciated 😉
thanks paul

[hilly]

Re: bosch w/m

I hope you’ve checked the heater then as that’s the usual cause for this fault! 😉

nice one 😀 one i never thought about there 😳 i will go and double check.

thanks

[hilly]

Re: inds**t f131kb1xgb single oven

has anyone any idea what temp the cooling fan should start and what temp the cut out should operate???

thanks paul

[hilly]

Re: brittannia range cooker

hi steve its a while since i was at this cooker but i think the lenses pushed onto the fascia then the neon clipped in from behind i think they are quite large, about 8 – 10 mm across

[hilly]

Re: hotpoint tdc62

hi ive looked at module nothing visible but if i tap it while its running it starts to go ok so i guess its the relay sticking! when i quote them for a replacement module tomorrow i think they will scrap it, oh well another one lost!

thanks for replies
paul

[hilly]

Re: candy cdi1012-80

cheers dave ill give it a bash 😆

[hilly]

Re: diplomat / servis type w/m

yes it got past the pause then it stops as it starts to pick up speed , seems strange how the pump and motor both stop, guess i will get a cost on timer first,

cheers paul

[Author]

Posts