Forum Replies Created
-
Posts
-
Re: Non-starting JLWM1203
Do an insulation test on the element because if they are low they can cause this form of fault.
Jem
Re: Whirlpool AWO/D 060 859230715010
If I have got the correct lights then that is error F27 in the image below.
Jem
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
That kit has been around for a while and I have fitted quite a few, you just use a 6mm drill bit to drill out the 6 rivets and bolt the new shaft on, easy job with no grinder required.
Jem
Re: Eslr9c lincat commercial cooker
You should be getting:
About 400V to 415V between Phases
About 230V between each Phase and Neutral or Earth
About 0V between Neutral and EarthIt definitely looks like a supply issue to me.
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
I have just bought a couple of the genuine parts and they look the same as the above image, looks like they have a 608z roller bearing in them now instead of the oilite bush.
Jem
Re: Indesit DIF04UK.R Dishwasher Flashing lights
If the motor is worn then it may not turn when powered so I would start by changing that.
Jem
Re: AEG L76650 Dead
Can you post some board photos please – from memory some boards have a bead inductor which may need changing.
Jem
Re: Zanussi ZDT12011/FA. leak in base.
The model is listed on my copy of the pressure switch mod service bulletin (page 16, right hand column) so I would suggest that you fit the mod.
Jem
Re: AEG L76650 Dead
Probably find that the fusible resister on the board is open circuit. assuming that that is the case then replace the SMPS chip (from memory I think LNK364) and the resister and it will be good to go again.
Jem
Re: Hotpoint 9549A – Motor Change
As the armature wasn’t available I ordered QUAMTR134 which was listed as the motor for this machine.
Many Thanks Jim, I will read that when I get back in.
Jem
Re: Zan ZKH7146J Dead. Is Board Repair Possible?
It will be the resistor and switch mode chip, I have done a couple and both are working fine after replacing those components.
Re: Electrolux EWG14750 e31
Its worth checking that the heating element has continuity and decent insulation resistance as I have had faulty elements bring this fault up before.
Jem
Re: JL (Zanussi) T Dryer dead?
The reverse polarity shouldn’t have made much difference although it may be possible.
My personal experience is that this range of smps chip will run for 6 to 7 years and then fail for no obvious reason after which it blows the bead style inductor and then the fusible resistor blows to stop further damage.Jem
