[HotDog]

Re: hotpoint problem

its an appox time but can extend the time if it needs to in short there isno fault have you timed it using your watch had same fault last year this was info i sourced

[HotDog]

Re: Indesit WIA111 stuck on cycle

if you cant cancel prog its board fault it will complete the last prog if left

[HotDog]

Re: creda simplicity. washer, w100fw

and a good time was had by all

[HotDog]

Re: Hotpoint WF530

check motor brushes

[HotDog]

Re: creda simplicity. washer, w100fw

drum shaft broke drum will drop cutting heater

[HotDog]

Re: hotpoint aqualtis aqgd1695

i have done two aqualtis machines both dead both needed display modules

[HotDog]

Re: sgi3002gb/07

thanks Chris you were right it did disp soap but motor didnt start just hummed removed lwr front plate to inspect motor it was red hot suspect somthing stuck or motor seized do you have to remove base fully to get motor out how long time wise

[HotDog]

Re: bosch dishwasher sgi3002gb/07

any advice before bed

[HotDog]

Re: Hotpoint 9404W

clean and grease shaft should do the trick but might need bottom bearing eay to fit

[HotDog]

Re: sps2462gb/19 dishwasher

thanks for info i am going back tue will a look at what you suggested

[HotDog]

Re: swan fridge freezer sr5090

cheers for that

[HotDog]

Re: bosch wft2800gb brushes

thanks for part number just snip and crimp then why didnt i think of that

[HotDog]

Re: bosch wft2800gb brushes

thanks for advice i have split motor the copper leads on the brushes are moulded to the ring what method do use to re attatch and trying to re assemble looks hard to take tension of brushes to stop them fouling armature

[HotDog]

Re: Hotpoint WMD960P very noisy.

never doubted his ability it i know it seemed to easy to miss

[HotDog]

Re: Hotpoint WMD960P very noisy.

sounds like restraint bolts still in

[Author]

Posts