Forum Replies Created
-
Posts
-
Re: Hotpoint WMA31
Moved to Trade Tech. 😉
I am almost certain I have a sheet for those, not the same as the ones you mentioned. Will dig it out and e-mail you later, after I have had my tea. 🙂
Re: HOTPOINT CTD40
I don’t have any codes on these yet.Still fairly new, hopefully one of our ‘friends in the know’ 😉 will give you a clue.
Re: Zanussi ZWF1020W
iadom wrote:Bummer. Just cannot get the machine into diagnostics cycle. Press the Start/Pause plus other option button, select first position and after several seconds ( more than 2 seconds) the only light that flashes is the ‘End’ light. It is still flashing 11 times, nothing else happens. module faulty????
I’ll take it from the absence of replies , that you all agree with the diagnosis. ❓ 🙂
Re: Market Research
eastlmark wrote:only 3 today.
This reminds me of being at school, we are talking MR forms and not pancakes aren’t we Mark. 😀
Re: Zanussi Dishwasher Mod DE 6850
Had one last week, a blob of solder on the module heater relay contact did the trick. 🙂
Re: ariston awd 12
Hi,
Count the flashes, is it four or five or more. These flashes are an error code, not always accurate but often a good guide.
A common and slightly expensive cause of this fault is the electronic control module burning across connections, but there could be several other causes including the pressure switch.
Remove plug if you intend to investigate further.
Re: Ariston OKRF3100l F/F
Thing is, they have actually sent him the seals. ❓ Logically, you would think that it would follow that they can be changed. Looking at my Hotpoint door seals they do appear to be secured under the lip of the door seal with a groove in the liner corresponding with a ridge in the seal. I didn’t try to remove a part of the seal to check for certain in case I damaged it. I wonder if they can be prised out ?
That said, logic and commonsense do seem to be in short supply these days. 😥
Re: Ariston OKRF3100l F/F
Anyone??? He has just phoned back to say that he has taken the doors off 🙂 . Are these seals/door liners glued in place ?
Re: Zanussi WJD 1667 W washer-dryer – dispenser drawer leaks
A good clean out of the drawer and the compartment it fits into is something to do on a regular basis. If your hot water is supplied via a combi boiler and you have a high mains pressure then you could try reducing the hot & cold flow into the machine a little using the two taps at the end of the fill hoses. Try and achieve a nice steady flow, not a gushing, hissing sound.
Re: One to keep an eye on.
Penguin45 wrote:I’ve just come in to find that one. What’ve you done? Told him to buy an inverter?
I haven’t replied yet.
Chris.GRRRRRRRR. tried to post this ages ago but it timed out.
He has replied to me and after reading his PM I told him that you are the man to contact Chris. 😆
here is his last message.
‘thanks for your reply,i work for fisher & paykel aus and as a hobbie i buy used fisher & paykel washing machines sometimes from the dump and u cant plug them in to see if the motor controller is blown, so u have to wait till u get it home to test it,so thats why i was wondering if there was some way how to test a motor controller if its blown without pluging it in.. ‘
Re: Zanussi ZWF1020W
Bummer. Just cannot get the machine into diagnostics cycle. Press the Start/Pause plus other option button, select first position and after several seconds ( more than 2 seconds) the only light that flashes is the ‘End’ light. It is still flashing 11 times, nothing else happens. module faulty????
