Forum Replies Created
-
Posts
-
Re: Indesit IDL40 lights 2 and 4 flash, but thermostat is fi
Not a thermostat, it’s a thermistor. 😉
2+4 is an open circuit heater fault.
Re: Whirlpool to do a recall on Hotpoint dryers
Hmmmm, wonder if this has anything to do with it?
Re: hotpoint WMUD 963 P UK drum bearings
It only takes seconds to remove the top and reveal the sealed drum, around £132.00 if your interested. 😀
Re: hotpoint WMUD 963 P UK drum bearings
You can’t, it’s a pile of Indesit made junk with a totally sealed outer drum. 🙁
Re: Whirlpool to do a recall on Hotpoint dryers
Still fishing, my guess would be a possible fire risk, can’t see them recalling all those machines because of the crappy rear bearing. ❓
Re: So how do I drain a hotpoint and not ruin the board?
Can’t say I have had one that pumps all the time, did have one yesterday where the customer had fitted a new pump and then the machine would not drain.
No amount of trying the reset procedure worked so referred him back to Hotpoint. Over the past few years I have ceased to be amazed at the failures of Indesit electronics but this has to be one of the daftest set ups ever. :rolls:
Re: iwme126
Reset is needed when the pump doesn’t work, continuous pump action is ‘usually’ the pcb. 🙁
Re: wma48 no spin
Worth noting that the reversing distribution cycle on some these is quite long before going into spin.
Re: Revisiting good old Vinyl.
I still have my turntable in the loft, it will plug into my 5+1 surround sound system and true to say the sound of the old vinyl is so much richer than digital in every way.
Re: indesit IDF125 pumps out all the time even with machine
Found a copy of the manual, check your inbox.
Jim.
Re: Hotpoint WMF760 Washing Machine Door seal.
Ha, three different version for that commercial code, bad news is that they all have the door seal that you have already got. 🙁
Re: wma48 no spin
Pressure switch reset is nothing to do with these machines, only for the much later Indesit garbage.
You could try and run THIS it may throw up a door not closed error but you never know.
Re: Hotpoint WMF760 Washing Machine Door seal.
Are you absolutely certain about the second number, there is no commercial code that matches 064662?
The only other seal listed for WMF760’s is a C00144134 which appear to be older models with a commercial code that is nothing like yours???????
