Forum Replies Created
-
Posts
-
Re: wm63p door seal
The same part number as the 1603006, bog standard WM seal. The seal lip was thickened up on later seals to prevent dribbles but TBH I have never had a problem fitting them?
Re: Hotpoint Aquarius WF000
Oh dear, F08 or the dreaded 8 flash problem.
Use the search facility for this forum and enter F08 and you will get lots of painful reading.
Supposed to be the heater relay faulty on the main pcb. 🙁
Re: non genuine Hotpoint dryer shaft kit – rubbish
fitted a couple a few years back, both failed in the same way within weeks, never touched them since. 🙁
Re: ariston d/w wash motor
As you can see from attached picture it doesn’t exist on the only software we have access to. 🙁
Re: ariston d/w wash motor
PS: Motor for LI45 is listed as a C00088121. Looking at the Google images it looks much the same as the Indesit models from a few years back, wonder if it was an export model?
Re: ariston d/w wash motor
Could well be really ancient but strange to have an LI45 listed yet no LI48??
Re: ariston d/w wash motor
There isn’t an LI48 according to Partfinder, perhaps its a 5 that looked like an 8?
Re: ISE 10 problem.
Got to be a 1406 or a 1606 with a drop down door and lights in a circle. We/I can send you the manual Mike, it might come in handy.
Jim.
Re: C00224176 – ToC for Creda built under
HotDog wrote: set of creda manuels
I didn’t know you had a set of Spanish waiters in your garage Cliff.
Re: AWOL
Hope the weather is a kind to you as it was to us in the Lakes last week, enjoy yourselves. 8)
Re: Hotpoint WMA31P Water fill low and conditioner used too
Changing the brushes should not cause this unless the connections to the control pcb had been messed with .
The main (only reason) the fabric conditioner goes in before the final rinse is due to overfilling the conditioner container and then slamming the drawer closed. Never overfill the container and close the drawer gently. 😉What level does it fill to on the rinse programme?
Re: Hotpoint Aquarious VTD6000 Tumble Dryer
Re: Hotpoint Aquarius WDL540 Problem
That error code does suggest it is not emptying correctly. Could be something jammed in the pump impellor, blockages in undersink hoses etc.
Remove the pump filter and shine a torch inside to see if anything such as a bra wire or hairgrip is stuck under the pump impellor.
