Forum Replies Created
-
Posts
-
Re: Indesit IDF125 3 Lights flashing. Washing,End,Start/P Li
Same as THESE
F11 faulty electronic control module. 🙁
Re: Hotpoint TDC62 no heat
A strong possibility the TOC stat which is a one shot device has failed. A thermostat kit is required. you should be able to test the two stats for continuity, the green spot one is the TOC.
Re: 3E error code
Re: Bosch washing machine: noise during spin
not easy but if you rotate the drum by hand through the door opening until each individual drum paddle/lifter is at the bottom then press down hard on the inner drum and see if there is any sign of it flexing. Sadly a very expensive repair. 🙁
I am not over familiar with this machine but some Bosch washing machines also get a knocking noise from the suspension units as well.
Re: Bosch washing machine: noise during spin
Possibly a broken drum support spider, the full model number would be a great help but it does sound like a major failure. 🙁
Re: Hotpoint FDL570P detergent dispenser issues
Where did you buy it from, what part number have you got, which ‘attachment’?
Re: Hotpoint WMA 30 Cuts out
The main test/ repair company used by the trade is EMW, however there is a strong chance that their testing facilities may not show up a very unusual fault such as this.
I once had a WMA pcb returned as ‘no fault found’ , the machine had an erratic motor action. By trail and error and a new motor and wiring harness I eventually confirmed the PCB as faulty . 🙁
Re: Hotpoint WMA 30 Cuts out
I see. 🙂
It does point towards a pcb fault but a very rare one indeed. :con:
The correct part number is C00199331 or the old Hotpoint number 1603828. Other boards will not work.
You also need to check on the age/ serial number of your machine because the wiring plug to the boards changed at date code 81.
Re: BEKO D/W overheating?
If as sounds likely this is a PCB fault does anyone know the part number/price of one of these?
Jim.
