Forum Replies Created
-
Posts
-
Re: Motor needed for Indesit Tumble Dryer Model IS70C
I have changed a few of these door interlocks and also had to replace the door latch once or twice, usually without further problems though. Your serial number is after the relay/pcb was discontinued.
Re: Motor needed for Indesit Tumble Dryer Model IS70C
The relay/pcb is part No: 145 in this diagram.
It was removed after serial number 60327.0000 when a new type of door lock was introduced.
You are trying to fit the correct door interlock as they are not interchangeable? Correct part is a C00195695.
What is the serial number of your dryer?
Should also mention that the motor also changed at some time during production. 😉 However I am as convinced now as I was at the start that there is nothing wrong with the motor.
It still points to a door lock problem.
Re: ISE 23W Washing machine problems
There is no ‘oil hole’ on this or virtually any washing machine bearings.
The bearings are not expensive and are quite a straightforward change if done in good time.
With reference to the hose chafing I always stretch the small spring at the back, this helps to prevent the drum catching the dispenser hose.
Re: ISE 5 error code and noisy spinning
Does your machine have a digital display with yellow numerals?
If it does then F05 is a heater or ntc fault, neither are major problems. The bearings can be replaced , not expensive but quite a bit of work involved .
Re: ISE10 washing machine broken- is repair possible now ?
lee8 wrote:In my opinion most Asko machines will need work by three yrs, .
That’s your ‘opinion’. but in my ‘experience’ of the 30 or more ISE 10’s that I have installed over the last six years only one has had a genuine repair, and that was due to very heavy use. All the other calls have been due to user error or misuse.
Re: ISE10 washing machine broken- is repair possible now ?
However, as ASKO machines more often than not last 15 to 20 years and more perhaps he didn’t know what he was talking about.
Re: Hotpoint BHWD129 washer dryer – door stuck
Bosch/Neff/Siemens built in would be the next best option.
Re: Hotpoint BHWD129 washer dryer – door stuck
They are all made to a high standard, if you can get a ten year warranty on that model and its features suit your purpose why not. Just do a comparison on spin speeds etc. Any load size over 6kg is unnecessary TBH.
Re: Hotpoint BHWD129 washer dryer – door stuck
Apart from not being able to refit the door/decor panel, as long as it fits in the hole then other than aesthetics no problem at all.
Re: Hotpoint BHWD129 washer dryer – door stuck
A Miele to replace an Indesit made machine, that’s not lazy, possibly the best decision you will make this year for certain. 😉
Re: Dangerous engineers , is there nothing we can do about t
So he was Corgi/Gas Safe registered then?
Re: Crusader 37667 – Intermittent fault
Do which ever you find the best, it’s in a stupid position and is a real PITA to get at. They did move it later and mounted it flat on the base.
Re: indesit dif 16 3 lights flashing
Part number is C00256546. There is nowhere local you can go and buy one of these. A quick Google for that part number will get you plenty of results but TBH buying it direct from Indesit is probably cheaper than a lot of the online spares places. List price is around £17.50 inc vat.
Or better still Right here 😉
Re: indesit dif 16 3 lights flashing
You can’t really check the turbine. It’s part of the squarish plastic chamber on the side. Not expensive and simple to change.
