Forum Replies Created
-
Posts
-
Re: Hotpoint FDAL28P dishwasher fault
99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain it uses the same codes as the FDL range. Sadly looks like 1+3+4. 🙁
Jim.
Re: Hotpoint 95492 Control Panel
Ha, that will get Mr Rankins hopes up for a second when he finds out he has had a reply. 😀
TBH his machine is a 95492, guess that was the easiest picture to link to?In fact this is his machine. 🙂
Re: Needing an engineer for isa10 still under warranty
Still listed HERE
Given the price I would suggest it is worth a punt, If you disconnect the wires to the heater and see if the lights come on the control panel that would point to the pcb being undamaged.
Leak from front left can be due to high water pressure and failure to remove the detergent drawer and clean out the soap dispenser aperture on a regular basis.Re: Indesit washer Dyer PWDE 8148SUK
It’s an Indesit, not the best and the elements on these are a common failure point.
Re: Indesit washer Dyer PWDE 8148SUK
99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain a new element will sort it.
Re: Indesit washer Dyer PWDE 8148SUK
musicman100 wrote: I tested the element and the thermostat with an altimeter
.WHAT??????
No wonder you got an ‘elevated’ reading. :rotfl:
Re: Indesit IWB6123
As per the Known Error Codes thread.
The flashing lights are not an error code, they just indicate that an error has occurred.
The bottom five VERTICAL lights on the far right are used to indicate errors, these lights do not flash but are on steady.
The lights are numbered from BOTTOM to TOP, bottom light is 1 and so on.
If you look in the known error codes thread all the fault codes for this machine are there.
Re: Needing an engineer for isa10 still under warranty
Sadly ISE went out of business a couple of years ago.
You may be able to find an engineer if you use the Search/Find an Engineer button at the top of the page, however any repairs will be not be done under warranty. 🙁
Re: Hotpoint Aquarius TCFS93BGP
Sounds like a control module fault. A visual examination of all components after first removing the mains plug is the first step.
Re: Hotpoint wdal 8640, detergent drawer filling while dryin
Some water runs into all washer dryers on the drying cycle, is your mains water pressure very high?
Re: Possible Heat Pump Dryer
Great Grandparents………my daughter still has one that does get occasional use. 8)
She draws the line at using the Dolly Tub, Posser and Mangle though. 😆
Fine in older properties with much higher ceilings than modern houses., often used for decorative purposes these days though.
