Forum Replies Created
-
Posts
-
Re: Bosch WFL2450
Has anyone got a service manual for this machine? I have been to look at it today but could do with a manual really, the connector onto the motor is shot and need a part number.
Thanks in advance…Re: raw appliances
When I say sorted, I managed to get hold of Marcus. Hopefully he may be the end of my never ending search for Raws, its a nightmare at the minute isnt it!
Re: raw appliances
Hi all, does anyone know if Marcus has changed his contact number or is still in the raw appliance business.? I am desperatley after Raw appliances and he did me a good deal or 2 in the past. If not anyone know of any other raw/recon suppliers? I am based in the Midlands and am after washers,electric ovens,fridges/freezers and dishwashers, prefer whirlpool but any would be great. I have been through all the raw posts with not a lot of luck to be honest! Please help 🙁
Re: sios disk
ASD have got no sios in stock and an order backlog! Typical. Can anyone suggest any other suppliers?
Re: Proline TDC6A Condennsor Dryer
An update, I replaced the start relay and its sorted it, happy customer.
Re: Proline TDC6A Condennsor Dryer
Ok, I have just been down to have a look as the customer is desperate (it’s 80 degress outside??) and basically after about 5 mins it cuts out, lights out the lot, mc is getting 240 to timer. When I keep the on/off switch pressed in the same, nothing…… any ideas? I still think its maybe the start switch
Re: Whirlpool “not spinning sometimes”
This model is a nightmare for out of balance, bet that is what it is.
Re: Whirlpool Integrated dishwasher ADG7540 beeping
You havnt been sent the wrong one, it comes supplied with the new connectors. Im assuming your current ntc has two terminal connections to it? If so you have to snip the old ntc off and fit the new connector (instructions in bag) and then re-connect by plugging into NTC, does that make sense?! 😯
Have you not a sheet of instructions in the bag?Re: ADP 8332
Look just below the lower spray arm and you will see were the upper spray arm clips into a cover, these regularly pop out caused by a broken clip causing the upper spray arm to lose pressure, replace the cover if this is the case.
Re: W/Knight cl767
http://www.ukwhitegoods.co.uk/modules.p … ht=#217558
Check the seal around the fan at the back, worn seal or the new rubber type let the heat escape up the back causing the switch to warp
Re: White Knight 767C T/D
The felt bellow was supercided by the rubber one and they are crap. Dont remove it though or it will cause the bottleswitch to warp at the top. I have had a load of these seals coming off or spliting allowing steam to escape up the back and melt the switch, I always re-fit the old felt type seal when replacing bottle switch.
