johnmac11

Forum Replies Created

Viewing 15 posts - 121 through 135 (of 1,760 total)
  • Author
    Posts
  • in reply to: 850mm Range cooker #403316
    johnmac11
    Participant

    Re: 850mm Range cooker

    Thanks Don,

    looks like the customer will need a slight kitchen refit…..

    John

    in reply to: Winter Tyres? #402725
    johnmac11
    Participant

    Re: Winter Tyres?

    I think there is a bit of confusion here, winter tyres and snow tyres are not the same. Winter tyres are used when the temperature drops below 7 degrees on an average day, snow tyres are for snow only. I have been using winter tyres for the past 4 years and apart from the initial cost of buying a spare set of wheels they cost very little to run. When I had the Merc estate it was diabolically bad in the wet/ice/snow and when I put the winter wheels on the difference is amazing. As Jim says they will take you up a hill covered in snow, not slip about in the ice and the stopping distance in the wet is vastly improved. I am in the mild Midlands and would not approach a winter again without having these tyres on my car.

    John

    in reply to: In search of the fourth cord #284763
    johnmac11
    Participant

    Re: In search of the fourth cord

    Too early to hit the town an as I was bored I did a bit of digging.
    Is this the same Jamie Parrie, 31 from Barry and does his picture remind you of anyone???

    http://www.faceparty.com/jamieparrie

    John

    in reply to: Whirlpool awoe8760b f08. ? #403037
    johnmac11
    Participant

    Re: Whirlpool awoe8760b f08. ?

    It appears to be a heating problem.

    John

    in reply to: fisher & paykel ff how to remove side panels in freezer #402292
    johnmac11
    Participant

    Re: fisher & paykel ff how to remove side panels in freezer

    torx bolt under the handle to tighten.

    John

    in reply to: bauknecht dishwasher #402387
    johnmac11
    Participant

    Re: bauknecht dishwasher

    Looks like a flow meter problem, pm me your email address and I will send some info.

    John

    in reply to: fisher & paykel ff how to remove side panels in freezer #402289
    johnmac11
    Participant

    Re: fisher & paykel ff how to remove side panels in freezer

    Some side panels have a solitary screw at the back which has to be removed but if no screw there extend both drawer runners on the side panel, put a towel over the end of upper and lower runners and grab both runners, push them back about a couple of inches and then sharply jerk forward and the side panel should then come free.

    John

    in reply to: whirlpool oven temp wont go higher then 160 #402119
    johnmac11
    Participant

    Re: whirlpool oven temp wont go higher then 160

    I cant find that model but assume it is a g2p90Fwh

    If it is this one and it has a static setting on the main oven that wont go over 160 I would be checking the upper and lower elements first, if they are both OK then I would suspect the main board. If it is on the fan setting and is heating to 160 I would go straight for the main board.

    John

    in reply to: whirlpool fop loader 3lsc8255eq1 tub off centre #401794
    johnmac11
    Participant

    Re: whirlpool fop loader 3lsc8255eq1 tub off centre

    the wonders of youtube attached…

    http://www.youtube.com/watch?v=pgjir05aBp0


    John

    in reply to: IOS.7 #401444
    johnmac11
    Participant

    Re: IOS.7

    Some people believe anything…….

    http://uk.news.yahoo.com/waterproof-iph … ml#Ix2q7Bd

    John

    in reply to: e522b fisher paykel #400482
    johnmac11
    Participant

    Re: e522b fisher paykel

    The part number for the main board I gave you is the latest one, the previous part numbers are 817850P, 820504P and 820818P

    Door harness is available as a spare part and costs around £16 ex VAT, part number is 814416P

    John

    in reply to: e522b fisher paykel #400480
    johnmac11
    Participant

    Re: e522b fisher paykel

    Hi Chris,

    Make sure you slide your fingers up each wire from the harness plug to where the wires go into the top of the door, it might look OK but you will feel an internal break if there is one.

    The main control board for that fridge is now part number 837765P and the retail price is about £85+VAT the user board is part number 821074P and retails at about £48 + VAT

    If you need any more info send me a PM with your email address.

    John

    in reply to: e522b fisher paykel #400478
    johnmac11
    Participant

    Re: e522b fisher paykel

    Check the harness at the top of the door under the hinge cover, if it is Ok then it has to be either the fascia board or control board.

    Post up the PN number and I will let you know the correct board if needed, £200 is way over the top and I would guess the board is well under £100

    John

    in reply to: Fisher & Pakel fridge freezer E522BRXFDU #399939
    johnmac11
    Participant

    Re: Fisher & Pakel fridge freezer E522BRXFDU

    Hi Bob,

    F15 will be a fridge fan open circuit.

    John

    in reply to: Plastic Outer Drum repair? #371234
    johnmac11
    Participant

    Re: Plastic Outer Drum repair?

    I just got an email from CPC who are now selling this stuff
    http://cpc.farnell.com/jsp/bespoke/besp … &CMP=NLem1


    John

Viewing 15 posts - 121 through 135 (of 1,760 total)