[johnnyj]

Re: Hoover vhd844db-80

Looks like a bin job Connect £215 and masterpart £160

[johnnyj]

Re: Indesit W123UK BG Program sticks on wash

Check for dry joints on the module, fixed a good few with my trusty soldering iron.

[johnnyj]

Re: hotpoint sy10x dead clocks

Usualy they start flickeing or fading away not had them dead yet.

[johnnyj]

Re: AMANA AC2224GEKB

Cheers Cras, thats the thing doing a repair for a friend you try and keep the the price down as they think you owe them a favour, not the other way round.

[johnnyj]

Re: AMANA AC2224GEKB

I’ve sent my email address a wiring diagram would be helpful, , i thought the condensor fan should still run but want sure how they were controled. jj

[johnnyj]

Re: Hotpoint WMA76

Def a brush driven motor, if you type in motor on connect for that model it shows an FHP motor with brushes.

[johnnyj]

Re: AMANA AC2224GEKB

Went back today and was advised it stopped freezing altogether i plugged it in and the comprressor and condensor fan come on for about 5 secs then goes off i tried another starter it did the same, i tested the compressor windigs i think they are okay ie approx 13ohms, 27ohms and 40 ohms across both windigs, not sure if it is the pcb or a siezed compressor, anybody got any ideas what to try next. JJ

[johnnyj]

Re: iwdc6125

I’d try the dryer thermistor 1st, they cause loads of weird and wonderful faults.

[johnnyj]

Re: AMANA AC2224GEKB

Thanks went back yesterday and it had stopped then was back working again, i had asked him if he had heard any buzzing like sounds followed by a click, he hadnt but is his wife was there this time she had, so i’m going to have a pop at fitting a new starter for the compressor, the other thing i thought it might be was the condensor fan faulty causing it to overheat and the compressor to trip out

[johnnyj]

Re: MJH Aftercare

Interesting reading dont know if i’ll bother, after the hassle i had from JTM in the past, i dont need any more of that.

[johnnyj]

Re: Hotpoint WD865 stuck on one minute

Usualy the wash element or wiring fault but another engineer told me the dryer element going down to earth can cause it also, i’ve not seen that one myself.

[johnnyj]

Re: Hotpoint WMA 57 fill valve pulsing

I’m sure in the distant past i had one doing this as Roy says i think it was the door interlock that that cured it.

[johnnyj]

Re: You can take a Hotpoint to water but….

Martin it’ll be the module had a few with that fault usualy the C00254298 one not checked to see if thats the one in that model JJ

[johnnyj]

Re: Candy FS615 ZEN Ovens

Cheers Kwatt couldnt find the models listed anywhere

[johnnyj]

Re: VTDOOP drum

If your careful you can prise the riveted shaft off with a screwdiver and fit the screwed shaft done a few now 1st one i tried i punctured the drum.

[Author]

Posts