[jontymox]

Re: AEG F35020VI (91153904302) Dishwasher Problem

Good afternoon,

Pleased to report that it was a faulty aqua stop.(solenoid jammed?)

Renewed above, and all well.

jonty

[jontymox]

Re: Bosch WTW86560GB/14 Tumble Dryer Problem

Good afternoon Andy,

I did wonder if that was the case, and tried re-setting by holding the start button down for 5 seconds or so.

Perhaps there is a different method of re-setting?

jonty

[jontymox]

Re: AEG F35020VI (91153904302) Dishwasher Problem

p.s.

I failed to mention that I’ve checked both pressure switches, and pipework which are fine, so I don’t think the control module is receiving false values.

[jontymox]

Re: Zanussi ZWT71401WA (914606024) Washer/Dryer- Drying Prob

Well,

I’m still struggling to cure this problem, and the Bosch dishwasher no heat fault.

“back to the drawing board on both these problems.”

jon

[jontymox]

Re: Bosch SGS45C12GB/16 Dishwasher Not Heating Problem

Thank you nomadPaul,

The water level is fine, and I’ve ruled out the heater relay/joint after renewing the control module, and the NTC gives a good Ohms resistance reading.

I’ll investigate low water pressure, and hopefully identify the problem.

Kind regards,

jon

[jontymox]

Re: Electrolux EOB846W1 (944250227) Oven Tripping

Good evening,

Yes, I did carry out insulation tests on the elements, which I should have stated.

I have found the cause of the tripping fault this afternoon… perhaps my system isn’t as sensitive as the customers’ as when I ran the fan oven for a few minutes the motor burned itself out, without tripping!

This despite the bearings being free, and the windings giving a good Ohms resistance reading.

New motor on order… hope that’s all it is!

jonty

[jontymox]

Re: Zanussi ZWT71401WA (914606024) Washer/Dryer- Drying Prob

Fair enough.

Sorry for the confusion; I trust I haven’t offended you.

jonty

p.s. as a tight-fisted Yorkshireman, I refuse to pay extra for sarcasm.

[jontymox]

Re: Bosch SGS45C12GB/16 Dishwasher Not Heating Problem

Good evening,

I have ascertained that the heater is fine, as is the related wiring to and from the control unit.

As damaged heater relays etc in the above are not unknown, I took the risk of ordering and renewing the module.

Alas, the problem remains.

Yes, I did carry out a live voltage test at the heater unit on the quick wash setting, and monitored it for at least ten minutes.

The customer had confirmed prior to my visit that the water was not heating, as I’d suggested this was the case for the reported fault.

As I was/am struggling with diagnosing this fault I did ask if the heater could short circuit, and damage the module… I was concerned it may have also damaged the new one, so yes, I should have carried out an insulation test on the heater first too.

Back to the drawing board.

jonty

[jontymox]

Re: Zanussi ZWT71401WA (914606024) Washer/Dryer- Drying Prob

Thanks folks,

I’ll thoroughly check the water flow etc, and let you know if that was the problem.

jon

p.s. Martin; sarcasm is the lowest form of wit. 😳

[jontymox]

Re: Bosch SGS45C12GB/16 Dishwasher Not Heating Problem

Dear Martin,

I am looking for constructive assistance in this matter, which you may feel you are offering.

I am not seeking insults and/or mickey taking by an “Appliance Master.”

In fact, I certainly do know how to Megger test a heater.

I did not Megger test the heater largely due to the fact that there is no power being supplied to it!

This remains my problem in diagnosing this fault.

Kind regards,

jon

p.s. it may make you feel superior in highlighting various sentences, and try to undermine other members, but in my view it does not.

[jontymox]

Re: Zanussi ZWT71401WA (914606024) Washer/Dryer- Drying Prob

Good morning,

The condenser itself is clear, so seems I should look at the water flow?

jon

[jontymox]

Re: Bosch SGS45C12GB/16 Dishwasher Not Heating Problem

Hello again,

I can confirm that I tested the thermistor, which is fine.

I didn’t Megger the heater for two reasons; there is no voltage being supplied, and I’m unsure how to Megger the element without connecting one of the test leads to the element itself.

The related wires from the module to the heater are fine, so I deduced that there was a module fault.

jon

[jontymox]

Re: Bosch SGS45C12GB/16 Dishwasher Not Heating Problem

Thank you Martin,

jon

[jontymox]

Re: Siemens SN65M031GB/14 Int’ Dishwasher

Returned to confirm faulty sensor in interlock.

Thanks again,

jonty

[jontymox]

Re: Bosch WVF2402GB/02 Washer/Dryer No Wash/Agitation…

Returned to confirm timer faulty, which customer asked to renew even though very expensive.

Thanks again,

jonty

[Author]

Posts