[kaibart]

2 things that come to mind,what wash programme are they using on washing machine as if the spin is less than 1200 there is not enough moisture getting out of the clothes so the dryer thinks the clothes are dry, other thing is that this dryer after it dried 1 load of clothes it needs time for the drum to cool before another load goes in so worth asking them questions as I’ve had loads with it switch off early as the dryer thinks the clothes are dry

[kaibart]

Water level error e01 code means so basically fill error

[kaibart]

Wount be motor as this has a motor pcb fitted could well be a wiring fault as I’ve had a beko washer with the same motor that wouldn’t go into a fast spin I ended up changing the harness worked fine ( I checked harness to motor and had resistance on all the wiring to) have you insulation checked the machine is the only other thing I can think of. Kai

[kaibart]

Turn your dial to 6 clock position then hold down the rpm button spin speed button then while hold the spin speed button down turn the dial clockwise to position 7 keep holding button for 3 seconds then turn the dial to the off position may take a few attempts and may well have to leave it then try again if you get frustrated

[kaibart]

Hoover nextra the traics normally blow to bits if a component is faulty think the machine is ber 14 years old and I’m no good with a soldering iron lol

[kaibart]

I have resistance on the outer 2 that’s what makes me think it isn’t the main board this is one off a dc machine with the rectified at the bottom the old pcb had motor action just wasn’t completeling cycle must be duff pcb then:rolleyes:

[kaibart]

Here’s the picture

[kaibart]

That’s the zanussi fix isn’t it bang it on the side

[kaibart]

Best fix ever;)

[kaibart]

I use the Stanley backpack plenty of room for all my tools I use on a daily basis and at £30.00 good value for money plus you have both hands free for carrying parts into customers houses

[kaibart]

Yes and they mixed up the top oven and bottom oven tocs and rating is different

[kaibart]

They have a problem with the placement of the tocs thermal cut outs on these dave may be able to help more with technical info as where they sit may have been mixed up since you had the oven

[kaibart]

I know I did warranty on all these brands they are an absolute nightmare dishwasher badly put together problems with electronics where you have to change display and main pcbs because of software issues I was so glad when they restructured and had 5 big service agents in uk I will not look at them anymore and it’s a relief, stops the hair turning more grey lol

[kaibart]

I think he would struggle with the modified tensioner or like you said a belt dave

[kaibart]

8mm is what you need kai

[Author]

Posts