Forum Replies Created
-
Posts
-
Re: Candy Part No. 41002726
You have a dc motor 1600 spin ceset only as the ohmic value on tacho is different and can cause issues if you fit a different motor and don’t reprogram the pcb
Re: Hotpoint CTD00P
These are photos of microswitch for ctd and tcm580 which there are no difference
Re: Hotpoint CTD00P
Check the model you have wiring for a different dryer hotpoint condenser dryers with a timer fitted have 3 wires to microswitch so yes it wil fit
Re: Candy Part No. 41002726
It depends on spin speed I would only fit a ceset motor as long as the shaft length is the same the older motors will fit kai.
Re: Candy GOC590- not heating
You test continuity at the thermostat and ntc you should get a reading of 0.5 ohms or around that if they are fine actually look at the heater some coils might be broken
Re: Hotpoint CTD00P
No it’s for a tcm580 which replaced the ctd model and the wiring is exactly the same as I’ve fitted loads.wiring different?? On new machines there is a 2 connection microswitch fitted on the old ones 3 connection fitted part finder is 100 percent that when product knowledge comes into it
Re: Masterpart Ceased Trading
Be interesting to see if they try and keep masterpart customers after them not supplying to trade who spread there orders around and spend under £400 pound a month I have vowed never to use qualtex again maddocks new web site and staff are fantastic
Re: Later hoover washer dryer condenser clean?
It is not removable only way to clean is with a coat hanger is 1 of those jobs that will probably come back after a week or so unless you spend a lot of time cleaning. Remove heater box then you can probably get access also clean the veins on the dryer motor fan they block up as well 😕 Good luck kai
Re: Hoover VHC681B stops with all lights flashing constantly
If you have bought direct you will have correct parts the wattage will be stamped on the heater if you have change 2 ntc 1 under drum and 1 in front duct and the heater and the lights ate still flashing the only thing you have left is pcb. Are the front and back fans clear ie no fluff? And have you checked condenser? These need a really good clean I normally advise people to use a jet wash to clean them out.
Re: Hoover VHC681B stops with all lights flashing constantly
There are 3 different type of heaters fitted to that model dryer 40004314 40006990 which have 4 wires and 40007271which has 3 wires if you haven’t bought a genuine heater the wattage might be wrong. I have also attached a picture of front ntc which should have a reading in kohms
Re: Hoover VHC681B stops with all lights flashing constantly
Does the drum rotate? There is a ntc on the font which requires a lot of dismantling facia off and front panel off to chang the pcb is in the front facia with the heater you changed did you pull off all wires and check continuity through each if you had 0.5 ohms it would have been ok
