Forum Replies Created
-
Posts
-
Re: DRCS 68 B Fan
Yes I’ve done 1 the fans are part of the motor so a bit of a job bearing pads and front seal will probably need changing to. Kai
Re: hoover dxc c48w3/1-80
It’s probably main module then or check ribbon cable from main module to display pcb
Re: currys essential dw
More than likely a blocked pump that’s all I’ve done on these pretty good to work on
Re: Bosch C/Dryer – WTV74309GB/15 Fault codes
I don’t know the fault codes but airflow is key have condenser out the pump resivour is more than likely full with fluff and the back wall of the dryer this is the only issue I’ve had with bosch condensers hope this helps. :eeek:
Re: CANDY DRYER GOC58F
There is a pressure switch listed for this model aswell so be worth checking that but it’s a drum out job
Re: Candy GCC 591NB tripping electrics
Because it’s been stored in a shed the heater is probably faulty but without using a megga (insulation tester) to check the appliance you can’t be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} the 31 number is inside the door which can identify how old the appliance is.
Re: Hoover WDYN656D
Do a insulation test some of the tri phase modules are earthed and more than likely the module if you get it in to test it will do exactly the same
Re: Bosch Classixx tumble dryer not heating up
Hi if you visit http://www.bosch-home.co.uk/store/spare you can enter the model number and it will show you where the element is 😉
Re: Bosch Classixx tumble dryer not heating up
You say you have continuity through the 2 thermostats this should be 0.5-1ohm and if you are checked the heater you should get a higher reading there is a front thermal limiter on the dryer to situated at the front somewhere and you should also have continuity through that as well if all have continuity it would suggest the timer has faild
Re: Beko WME8227W wont start
Hi I would 1st check the brushes failing that motor or pcb will be faulty
