[karv]

Re: Diplomat ADP5330 Not fully heating, different cut off te

when you say cuts of do you mean everything goes dead or just the heater goes of?
3 elements i belive
these are all gueses
stat is faulty and is over heating and everything is cutting out very rare

on this model bottom/or top element most likely blown on the conventional oven or door hinges are worn broken/or seal is dmg at bottom and missing letting to much air out.
if on fan oven the fan element gets to 200 or 180 then struggles to get any higher nm how long u keep it on going by the dial and neon never goes out , and its not burning everything and it still don,t seem to be getting hot enough inside then , i would say door not closing 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} tight or seal.

[karv]

Re: Diplomat Washer Dryer – Tub banging

my first question would be do you have a wooden floor, these machine love bouncy wooded floors .
Then i would double check machine is balanced and all locking nuts on feet are done up and also screw the feet all the way up if its vibrating alot but will make door out of line with rest of units unless u put a work surface or somthing under it.
allso a uneven load or unbalanced machine will cause concret to hit front of machine during the first slow down from very first short spin.
if none of this helps i would go for 2 new suspension legs

[karv]

Re: Help – Diplomat ADP8322 Doesnt fill with water

most likely you will need new bit , i don,t think u can get on its own belive u may need to buy new air break aka the plastic chamber with new 1 sensor bult in, unless this site as them on there own.
the odds of being the main module or wire loom is possable but are low odds

[karv]

Re: Diplomat ADP8322 upper spray arm not rotating

i would replace the spary arm and tougue , i,ve had a few where it don,t turn anfd is no reason to explain it other than the old arm is naff hehe

also if the feed pipe at bottom as come out no good pushing back in the clips holding it it will be broken and it will keep comming out , u will need to replace the cover that holds it in place.
I never had a motor cause just the top spray arm not to turn while bottom arm is wizzing around at full speed. i personal would only change motor if u was getting strange noises or if i was getting black bits appearing in the water.
motor is costly to replace but they are common problems on these machines

[karv]

Re: DIPLOMAT ADP 1520

hi
MAKE SURE ITS HAS NO POWER BEFORE U DO ANYTHING
I would say few poss causes
i would go for a burn,t terminal block or if u lucky just lose screws on the terminal block or burn conection wire on pcb or worst case big time blown pcb.
pcb,s are costly

also
alot of times the pcb sensors have moved from glass aka pcb has dropped. on the bottom of pcb is grey strip pushing pcb up to glass can try moving that around .
But if it came on then went of came on now nothing , i would say burn,t or lose connection.
don,t forget ovens and hobs are 2 diffrent machines be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure its dead and don,t presumme the big red switch will turn it of

[karv]

Re: Diplomat APM 8513 Timer

sounds strange i would guess for a module.
you can get lots of strange module faults on those machines.
nearest thing i can think of to that fault is door locks and nothing happens= module.
part number may be on front of machine at bottom

[karv]

Re: Diplomat / Hygena app 2410 cooker hood

allways avoid trying to taken them down if you can , you end up dmg the paint or plaster or the grating to the tiles , turn the main power of at fuse box will be easyer. aka everything is dead , once dead you don,t need to removed the extractor to replace the pcb anyway.
you mayfind that u can just re soilder the joint thats losse or replace the pcb,
ps also handy to have a small gas soildering iron in those situations or a long extension lead if u 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure you have isolated aka turn off the power to the kitchen and oven+ oven socket and use a electric soildering iron

[karv]

Re: Diplomat Select GT 60DL Spark electrode

this site as rules about advising people about gas. for good reasons
as no one has answered my advice would be to contact extracare.
many places will not sell gas parts to non corgi people , for good reasons

[karv]

Re: Diplomat ADP 8322 F6 fault

before u call someone in just be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure water is going in.

[karv]

Re: APL8224/3 – no water circulating

hi ya im no expert but belive that is brant version of the diplomat.
if was making noise while spraying during wash will be motor they often go that way they really make a struggling noise when they on way out.
poss a leakie pipe thats screwed ya motor over as well if this is case u will see water signs on motor.
they do have capactior as well but noise would be motor it self.
3 versions of motor or the motor with mod kit that fits all , this site may do a universal motor that fits i do not know tho.
as for fitting 1 type is dead easy clip and turn / 1 type is flaming nightmare clips and seals and moving capactior or adding it that come with new motor/ thrid one i don,t remember .
price 100 to 135pounds i would say with vat at a guess .
if worth doing ? depends on age of machine your call hehe

[karv]

Re: Diplomat ADP 8242 Help!!!!!!!!!!

hi ya im no expert but i belive that could be hard one many possible answers/causes may need engineer

have u tryed hold ing button down for 10 secs to reset it and reset pc from test programme , info on this site about it i think.
module could be faulty or blown
low insulation from componets on these dishwasher can cause many problems
does it work after u not used for while
could be a leak thats cauing low insulation check base for leaks or signs of leak if so most liekly from white air break washers/o rings
the anti noise fitter maybe starting to blow/ cylinder shape near where the mains wire connects to dishwasher can normal see my sight if it has.
just some suggestions.
ps does the door close ok? do ypou hear the click as u close it?

[karv]

Re: Hygena OvenStuck on Automatic

only like 2 to 4 wires going to most timers some live some neutral never had that fault myself. don,t think new timers are that expensive on most ovens some are tho.
ps its not something silly like the clock or pannel have moved out of alinment and rubbing on the button keeping then pushed in ?

[karv]

Re: Diplomat 3650 Only Fan and turbo setting works

did i miss read this is its still not working while the engineer was there and he said there was nothing wrong with it ? and was u there to explain the problem ?
or you saying he said nothing wrong and its all working now? and he just could,t see anything from?

[karv]

Re: Diplomat Range – Top oven on when oven switched off.

Can’t think what oven that 1 is at moment, but there a a few Diplomat range ovens that suffer with faulty stats in top and bottom oven. When u have the dial to off yet it gets warm generally not very hot, but just warm.
Stats are always the cause of the problem. They are what power the oven and its basicly powering your oven when the dial is off postion.

[karv]

Re: Hygena AHY8102 Door Handle

im no expert but
if thinking of right one , the 2 hooks go in easy at top but u have to have patience and put facia and handle back on together but get bottom catch of handle to go into door lock as u put it togther , as well as all the bottom catches on the pannel, somtimes pulling the handle abit as u put them together helps. taking the ridged section below pannels helps.
you know when u done ok as door handle is near flush with pannel and pannel is in tight at bottom and top and handle has some tension don,t force it hehe and buy a stress ball

[Author]

Posts