[Kentish]

If it’s like the Miele system, the door has to be opened almost fully to release the mechanism. I have had a couple of the release mechanism need replacing down by the door hinge.

[Kentish]

Have had them clog the base.

[Kentish]

Can you not just dry it all and adhesivo it?
Ive not had one not seal that way.

[Kentish]

It’s the fluff clean reminder. They need to run the fluff clean (I always suggest every 3 drying) regularly.

[Kentish]

Have you checked the wash motor impeller for debris blocking it?
That would be my go to check first.

[Kentish]

Sent .
cheers m8

[Kentish]

don wrote:There is a DDCH90 downdrat hood info I can lay my hands on if it helps. H would seem logical for Cooker Hood.

M and H?

Don

Sorry, you are quite correct and I didn’t read my writing properly. DDCH90

[Kentish]

My check list.

door striking low in the lock, door loose at hinge, door switch finally PCB.

[Kentish]

Dryer elements or the dryer TOC are what I usually find causing tripping with Zanussi based washer dryers.
so much so, I carry both parts now.

[Kentish]

It’s the older style direct mount. It will be the hinges, but replace them as a set.

[Kentish]

Aswo is my first choice now. They are normally cheaper than the manufacturer and quicker. Their pattern stuff is good quality as well.

[Kentish]

I’ve never seen the lid riveted in place, are you confusing the slide off fixing?
Lid should slide back and off once the screws are removed. Then drawer out, screws holding dispenser, fascia and mounting plate perpendicular off, then 2 joining plates for the cabinet seems, 2 screws holding the 2 halves about 6;inches down , door seal off the front, 3 screws underside at the front and then from memory that is it and the front cabinet half lifts off. It isn’t that hard to do, just needs a careful approach and not afraid to remove things.

[Kentish]

iadom wrote:Don’t think machine is that old, no more than 4 or 5 years at the most. I can e mail you the video possibly .

I think you missed a 1 off the front of those numbers

[Kentish]

Have you checked the side chamber valve not leaking on it’s O ring when filling?
Had that plenty of times

[Kentish]

There isn’t a lot of difference,. Pop the caps off the plastic lower panel screw covers, 2 tor’s 20#, pop the plastic panel down, then 2 torx20 at the bottom of the front panel, door switch screws and the single tor’s in the middle..
easy Peary:)
I do find though that removing the decor door first makes life a lot easier

[Author]

Posts