Forum Replies Created
-
AuthorPosts
-
kwatt
KeymasterRe: beko bdvc563ak oven turns of after a few minutes
Usually the cooling fan stat will be open, closes when hot.
Safety will be closed, opens when overheats.
No clue what they look like, it’s a generic parts drawing I’d be looking at.
K.
kwatt
KeymasterRe: beko bdvc563ak oven turns of after a few minutes
There’s usually a cooling fan control stat and a safety stat.
Explanation here: http://www.ukwhitegoods.co.uk/help/spar … hermostats
If you disconnect the cooling fan motor it’ll get hot, fast. Possibly damage other stuff and cut out on the safety stat.
K.
kwatt
KeymasterRe: Best oven in Cyprus
Honestly, if you do that it really doesn’t matter what you do as it will probably fall apart in a year or two if it lasts that long regardless.
I don’t know what the position is in Cyprus but I’d expect much the same as here and, if that’s the case, the five year warranty may well not be honoured, explained here:
http://www.ukwhitegoods.co.uk/help/buyi … appliances
K.
kwatt
KeymasterRe: Ptc start device and overload
Sounds like the compressor is fried.
K.
kwatt
KeymasterRe: Premium Contract Work
Not yet, ongoing. 😕
K.
kwatt
KeymasterRe: beko bdvc563ak oven turns of after a few minutes
Sounds like a cooling fan or cooling fan control stat problem.
K.
October 4, 2016 at 6:47 pm in reply to: Hotpoint Condenser Dryer TCL780 Only Heats Up On Set&Forget #441507kwatt
KeymasterRe: Hotpoint Condenser Dryer TCL780 Only Heats Up On Set&For
If you mail Dave on spares@ukwhitegoods.co.uk he’ll find it for you as cheap as it can be gotten most likely.
K.
kwatt
KeymasterRe: Approved Repair Engineer Pages
For that, yeah pretty much give me an idea of what you want, the text in general etc and I’ll cobble something together for you.
K.
kwatt
KeymasterRe: Red tape gone mad!
I know what I’d tell them to do with the job. 😉
K.
kwatt
KeymasterRe: directrepairandtechnicalsupport.com
Nope and, it’s not off to a good start either…
K.
kwatt
KeymasterRe: Fridge too cold motor running constantly
From what you say, it’s only really the thermostat that could cause that to happen.
Are you sure the stat phial is correctly installed, it’s not kinked or broken as if it were, that’s what’d happen.
K.
kwatt
KeymasterRe: Beko DW603 Leak
We had another similar one like this here a while back, not sure if it was a Beko or not though.
With integrated when that happens it will invariably be that something isn’t quite square and level and the cabinet and/or door is being twisted very slightly so it doesn’t seal just quite correctly.
Detergent etc will have no effect on that.
K.
kwatt
KeymasterRe: AEG dryer motor
Shows OOS everywhere Jim which is usually indicative the manufacturer has none and will often prove to be a precursor to the declaration that it’s obsolete.
K.
kwatt
KeymasterRe: Rangemaster 110 fan oven
A lot of them are multi function ovens that can be used in different cooking modes.
K.
kwatt
KeymasterRe: Rangemaster 110 fan oven
Sounds like a stat issue if it’s using the fan oven mode.
If it’s a static oven or used in static mode then it could be the upper or lower element, which would be more likely with that sort of report ordinarily.
K.
-
AuthorPosts
