Forum Replies Created
-
Posts
-
Re: zanussi oven
Been to same cooker before and nearly got caught out by the same thing manual is wrong and misleading. Managed to get zanussi to help by saying I was with service force. 😀
Re: LG Dishwashwasher
How old is this model ❓ As a few years ago LG did a modi. pcb because old was catching fire on a small number of dw which caused various faults apart from the obvious.
Re: Bosch Dishwasher SGS43A18/GB27
Did you check the dispensor with or without a tablet in ❓ ❓
Due to sizes of different tablets dispensor can stick. Have you used correct soldnoid and connected lever up correctly. ❓
Re: Merloni error codes
F13 = High Temperature Rise in Drying: Reduced airflow, check fan motor & filter for blockage.
F14 = No Heat when Drying: Check one shot thermostat, heater & module connections.
F15 = Drying Heater Relay Fault: Possibly open circuit.
F16 = n/a
F17 = Door lock error: check door, door lock & module connections.
F18 = Fault on Control Board: Check for damaged EEprom and Microprocessor.
Hopes this helps by finishing the list. 😀
Re: Hotpoint WT540/1p head scratcher!
If I remember correctly this is led 3 & 4 flashing. If so fault listed below.
F03 NTC short/open circuit: check thermistor & module connections.
😀
Re: hoover fridge freezer
As per hoover site it is :-
THE DURATION OF THE DEFROSTING OF THE FREEZER’S EVAPORATOR
WAS SHORTER THAN 15 SECONDS, FOR THREE TIMES IN SEQUENCE.hopes this helps. 😀
Re: LG WM16220FD Wash M/c No Motor Action?
Depends if customer means IE or LE !!!!
LE LOCK ERROR CHECK LEAD 3 PIN TO STATOR – PCB LEAD – REPAIR REPLACE HALL SENSOR IN STATOR FAULTY REPLACE STATOR
IE WATER INLET ERROR WATER NOT REACHED PRE-SET LEVEL
Re: Interesting Hoover AS 120 spin fault
Low insulation on hoover heaters can cause all sorts of wierd and wonderful faults. So now I always check heater first 😀
Re: Indesit IDE 1005 uk2,door seals
If the door seal is clamped into the lower part of the door you will need to order the inner door.
On diagram goal post seal is :- c00141317
Inner door frame stainless steel is :- c00097501.Lower door seal not shown. 😀
Re: Whirlpool awm9100/1
Part number :- ring bellow front spring 4812 4011 8621
ps your 12nc number is wrong should be 857008415001 😀
Re: Bosch Dishwasher sgs43a18gb27
As per bosch website module number is bosc482935 which changes to your number so should be ok. Did you try module before doing mod. ❓
Re: Whats the most annoying thing customers do?
Ring them in the morning with a rough eta eg. 12-2 then ring again when on the way and say “I’ll be with you in about 15 minutes” then when you arrive they say “I cancelled this call yesterday didn’t the office tell you?” no they did not and neither did you, either times I called you.
Never mind southam isn’t that from wolverhampton only 90minutes away. !!! have a nice day 👿
