Forum Replies Created
-
Posts
-
Re: hoover fridgefreezer hnmf282805a
lol went to your web site sent it there any ways wll send it to other 🙂
Re: Hotpoint ff 200e
turn both buttons clockwise fully then all the way to off then back on again
should clear it 🙂Re: Indesit WIXE167
look here http://www.ukwhitegoods.co.uk/modules.p … ic&t=51155
1st page 1st one 🙂
Re: Sharp R7A50 Microwave tt motor &oven light on all ti
ah been cought out on this one to have a look at the cam that opens and shuts the flap to the microwave cavity air flow it may have melted stopping the cam to switch off to the stop position , it wont finnesh till it does ..
hth l not sure on that model thow 🙂phil
Re: Bosch waa24171gb/12 Reset
rolf wrote:To be honest loopey it’s a good idea in theory because it stops the customer from frying the motor by constantly selecting spin.
When I changed the brushes there was no signs of the braid scoring the com like you often get with bosch brush changes.
What would be handy is a list of all the reset procedures because it looks like we are going to see a lot more of this.
Bernie wrote:I would like to agree with Rolf
“Would be handy a list of all the reset procedures”
Bernieyes i agree with both of you 110{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} would like to see a little more info on the bosch machine resets .
I have hered on the grapevine as a customer did bye a part from bosch website , Fitted it and set the kitchen on fire , but thats just
a rumour 🙁phil
Re: WMA Torx bolts
yes the heat treetment does work 🙂 also tighten it 1st helps and a good wack with a lump hammer can loosen it up, and a good quality torx bit…
broken hundreds of the cheap ones 😡Re: Bosch waa24171gb/12 Reset
ok good result will remember that one for future finger twisting button pressing getting no were bosch lol , all for the changing of a simple part
that has failed or worn out .Hope more people respond to this little rant 🙁
Re: Bosch waa24171gb/12 Reset
you can try this , it has worked on a few …….
To reset it.Turn the appliance knob to the off or reset position, 12 o’clock.
Turn the knob to the 6 o’clock position.
Press and hold the spin button.
Whilst holding it, turn the knob to the 7 o’clock position.
Continue holding the spin button for about 5 seconds.
Release the button.
Turn the knob to off.
When your turn it back on it should have cleared the error code
Re: bosch wte84307gb05 wont start
have a read here 🙂 child lock may be on 🙂
Re: Hoover F/F HF 27C
I am stumped on this one i know they exist have worked on them , but no joy on hoover web site with taht model number 🙁
Re: Hoover Dishwasher
the heater is on the back wall 🙂 pressure switch i would be looking at . also check connection on pcb and for dry joints 🙂
