Forum Replies Created
-
AuthorPosts
-
loopey
ParticipantRe: INDESIT WASHER
1st post here should sort it http://www.ukwhitegoods.co.uk/modules.p … ic&t=51155
loopey
ParticipantRe: felt bearing beko drcs 68w dryer
A little tip that sorted one of these that kept braking up the front felt added some baby powder to front felt , also used chalk powder that was 15 years old from the good old hoover tumble dryer days .
hth
philloopey
ParticipantRe: bosch wae 28467 uk strange bearing noise
it has to be the belt had a couple of bekos with the same fault , belt changed noise gone 🙂
loopey
ParticipantRe: Bosch Dishwasher SKT5102GB does not fill enough
water tank on the left hand side looking from the front is clogged up . side panel off you will see at the top left of the tank will be gunged up , were there is an air brake , take it off and rinse through with hot water and bleach
give a good shake helps .hth
philFebruary 21, 2011 at 4:10 pm in reply to: Bosch WAS32466GB How do i reset the machine please???? #345293loopey
ParticipantRe: Bosch WAS32466GB How do i reset the machine please????
have a read here http://www.ukwhitegoods.co.uk/modules.p … ht=#299023
loopey
ParticipantRe: Hotpoint CTD00 Dryer won’t keep running
relay goosed connects part number 5045170933371 they are repairable
thow its usually the 1uf or 1.5uf capacitor that needs changing 🙂EDIT its a .68 uf (sorry heavey weekend )
loopey
ParticipantRe: WTS58650BGB/11 door lock symbol flashing
Thanks martin 🙂 he he it was monday morning
loopey
ParticipantRe: Hotpoint F/F FFA52P didn’t restart after defrost
its usually the black connecter on the pcb near the relay that gives trouble
just crimp it up 🙂loopey
ParticipantRe: indesit IS70C tumble dryer
Tubs wrote:Hi all
Not seen this before, rear drum bearing has usual failure but the drum shaft is part of the whole drum, rather than being held on with the three torx fixings. Surely you dont have to hacksaw it off to fit new shaft assy??
Steve
yes thats all you need to do , quicker with an angle grinder 🙂
loopey
ParticipantRe: candy washer cm range, stain light flashing
cm rangew error 5 is Faulty NTC Temperature Probe and/or Defective Core
Board and/or Wiring. Ohmic Values of NTC are: 20
Kohm at 25°C – 2.14 Kohm at 85°C.loopey
ParticipantRe: Hoover Washer Dryer
sent you a little reading . i agree with what they said up above 🙂 selector
loopey
ParticipantRe: Bosch Microwave Oven – HBC84K550B/01 E8 Fault
internal fuse has gone ? did one last week sticky door micro switch was the cause , hth
phil
loopey
ParticipantRe: Exploding Candy Washing Machines
These hoover candy machines have been exploding for years but they
wont admit it .. how do i no well i used to by all the raw from hoover saw
alot just like it , i have pics some were see iff i can dig them out , as whiskey_six said it the seam that gives away every time ……heres my very own sisters hoover six that went with a bang lol
loopey
ParticipantRe: Hoover HNMF2605A Fridge-freezer
post sent 🙂
loopey
ParticipantRe: Hoover HNMF2605A Fridge-freezer
Email addy please will send you pdf test page
-
AuthorPosts


