[loopey]

Re: miele disdhwasher

ok cheers for that will check it out 🙂

[loopey]

Re: Hotpoint Fridge Freezer FFA 52P in Marley Outhouse

BEKO CDA648FS 11.0CF

11.1 cu ft Frost Free Fridge Freezer

11.1 cu ft / 313 Litres, Efficiency Rating: A, Frost Free, Auto Defrost, Reversible Doors, Clear Drawer Fronts, 3 Safety Glass Shelves, ###Works in -15C Conditions###, H: 1906mm W: 595mm D: 600mm, Net: 9.5 cu ft / 269 Litres

hope this helps ##

[loopey]

Re: Candy Dishwasher. CDI 2/180

possable dry joint on pcb or circ pump

hth helps phil

[loopey]

Re: Indesit IDL40 dishwasher pcb

It is pre-programmed 🙂

[loopey]

Re: Servis M0330 Fridge frrezer

change the 1 uf cap on board all will be well .. done hundreds 🙂

[loopey]

Re: ROSSAIRE 2040dbuk

i think we are snowed in with out a shovel 🙁

[loopey]

Re: HBN13N520B/01

have orded same part from connections INSTOCK to iff that helps 🙂

[loopey]

Re: ROSSAIRE 2040dbuk

Nothing coming up with that model number on hoover website
give any other numbers or product numbers ?

[loopey]

Re: Your most used tool?

All of the above ^ apart from the kneeling pad there built in to my pants
and my trusty neon screw driver , we all need pants

[loopey]

Re: Identifying Compressor Suction and High side pipes

lol in 30 years fitting comps made the same mistake this week , i did get the pipes the wrong way round , as being the suction pipe was smaller than normal , gased it up , switched on ff wotched the gauges go up and up lol , well it was monday mornining .. 😳

a good tip iff not sure blow down 1 of the suction pipes the other will here a sound out of it , .. WE ALL MAKE MISTAKES NOW AND THEN …..

[loopey]

Re: Beko DRCS 68W Cond Dryer

its a sensor dryer , did you put wet clothes in in to test 🙂

[loopey]

Re: Hoover HNWL 6136 – 80 washer/dryer

these m/c have a seperate pcb for the dryer side its located at the bottom rear of m/c , probs just a dry joint , ..

is it showing any flashing lights , count the number of flashes , for fault code can send you some stuff iff you like ……….

phil

[loopey]

Re: Hotpoint CTD – Empty Water Light on

check the wires that go along the back panel under the drum have not been rubbed away by the drum .

[loopey]

Re: WF000

try drying out motor block with hair dryer , fell for that one a couple of times , after doing bearing jobs ,,

hth phil

[loopey]

Re: zan fx1365w

yes checked brushes , also changed motor and heater , pcb fitted problem
gone 🙂

phil

[Author]

Posts