[loopey]

Re: Hoover HFA270 fridge freezer freezing in the fridge

Dimension H (measured from the top
edge of cabinet): 168 mm.
Dimension L (measured from the left
side edge of cabinet): 172 mm. at the rear when condenser has been removed …

hth phil

[loopey]

Re: Candy GO146

mega the heater had a simular one today new heater sorted it 🙂

[loopey]

Re: Candy GO146

ERROR 7(MDL) – Jammed Motor’s Rotor and/or Wiring.

ERROR 7(INVENSYS) – Defective Door Safety Lock Device (blocked closed) and/or Wiring.

ERROR 8 Defctive Tachometric Dynamo (opened or shorted) and/or Wiring.

[loopey]

Re: Hoover HFI3015-80

hmn shouldent have door furniture on it , it should have plastic suround
holding in colourd formica matching the kitchen …

hth phil

[loopey]

Re: Hotpoint WD Series & H20 Error

h2o is no water surpply water turned off or kinked pipe usually

hth

[loopey]

Re: Google Search

page 8 for me . got to agree with martin on the key and metor tags
nice site by the way 🙂

[loopey]

Re: I am sure it is easy when you know how HPT WF541P

weak spring ? have bent a few that have gone weak , may be strained by customer ..

[loopey]

Re: Belling Diswasher E5?

its a smeg , well most i have worked on have been .. poss valve gone or water in base ?

hth phil

[loopey]

Re: Whirlpool T/L 3RLEQ8033RWO

have been selling these with Domestic & commercial warrantys
i would give them a ring thow see iff they registed it ..

[loopey]

Re: Baumatic bdw15 lower spray arm not working

take valve off remove flap . its only energised once pump is active
, the force of water keeps it in place they do stick some times ..
hth phil

[loopey]

Re: Hotpoint Fridge Freezer FFA 52P in Marley Outhouse

from a friend at beko…

Hi,

I have been asked to supply an answer to the question in the subject line. It is subject to patent so cannot give exact details but if a standard fridge thermostat (which also controls the freezer) is not switching the compressor on because the ambient temperature is too low, the freezer contents would start to thaw out. On our electronic version, the software constantly monitors the state of the additional sensors in the product and if the freezer temp. starts to increase for instance, the software will ignore the thermostat setting and turn on the compressor anyway thus maintaining freezer temp.
Hope that helps.

phil

[loopey]

Re: dg6100/1

thanks Chris got it 🙂

[loopey]

Re: NEFF dishwasher no heat

broken wire at front door harness more than likely. had one last week

hth phil

[loopey]

Re: Zanussi dishwasher

1st place i would look at is pcb for dry joint ?

[loopey]

Re: miele disdhwasher

😳 dunno what ive done but its working ok now lol . did have a look at the wire matrix on the right hand side .. ? tightend up all the connectors …:)

[Author]

Posts