Forum Replies Created
-
Posts
-
kwatt wrote:As for the one with the music
It’s a catchy little toe-tapper nevertheless….. 8) 😆
Martin
Re: Mozilla Firefox
……but the gutting thing is that the new DASA website doesn’t work through Mozilla Firefox 😥
Martin
Re: Mozilla Firefox
Thanks for putting me on to Mozilla. I downloaded the browser and it works brilliantly 🙂
UKW works quicker through it too :tup:
Martin
Re: Bosch Maxx 100 washing machine wash out failed
No need to take the lid off Frank!
Just poke a ‘cable tie’ or similar thin tool through the holes in the top of the dispenser cavity adjacent to/and above the fabric conditioner compartment.
They block up with bacteria build-up and doesn’t need too much effort to clear with the right tools 🙂 😉
Martin
Re: Indesit WD12 Control Board
Pete,
The main circuit board part number is C00093153 Cost around £95
Martin
Re: indeset we16 fault code F05
Well if you do want a replacement Pressure Switch for that machine of yours it’s Part No: C00075337 (Cost around £15 ‘ish)
Just let us know 😉
Martin
Re: indeset we16 fault code F05
Gaz,
It’s not certain the fault is caused by the Pressure Switch or the connections from it to the Control Module. Also there are 3 different Pressure switches fitted to this model, so we would need the full model and the serial number first.
Do check that the drain pipe outlet is not restricted first 😉 On occasions getting an F05 error warning means the ‘drain out period has elapsed’ and therefore the machine goes into error. In fact the machine should drain from full to empty in less than 60 secs, if it takes longer it could be restricted 🙄
Pressure switches do indeed go faulty though, so it could be that?
Martin
Re: Amusing Ancedotes & Other Tales
Customer complains : Washing Machine not filling!
I get there and sure enough no water going in, valve seemed fine took hose off back -No water?
Checked stopcock, works fine but no water to that? Asked customer where mains stopcock is, checks it, works fine, still no water to machine. I decided to trace water pipe between both stopcocks to see if any others in line, to do that I needed to pull fridge freezer away from wall!
It was well stuck and a lot of hastle to pull away from the wall, in doing so a bit clang! bang! and rattling of water pipes was heard. On getting it out and looking behind, found the foam insulation had broken down, great solid mass of ice covering the wall and the water pipes.!!!!!
After a short thawing out, the washing machine was back in action. 🙂
But oh dear missus, your fridge is well duff I’m afraid ❗ 🙁
Martin
Re: Basic Electrical Safety
Something like this eh guys 8)
http://www.angliacampus.com/education/fire/secondar/plug.htm
Martin
Re: ‘No Call Out Charge’ beware!!!
It’s good that you put it on the ‘homepage’ too by the way :tup:
Martin
Re: Siemens SIWAMAT 2105 not draining!?
OK general, then now set it to a ‘Rinse & Spin’ cycle, let it fill with water for a minute or so until you see the water appear in the drum. Then stop it and reset it to spin, see if it drains out OK????
Martin
Re: Hair Cut
Dave_Conway wrote:I haven’t the foggiest idea wtf you’re on about 😕
Poor old Dave, he misses out so much, living out in the wilds of Devon with only cows for company 😆
To be honest, I was tempted to loan him my DVD of the movie to which WE refer 😉 , but on second thoughts he would’nt know where to stick it ! :rotfl:
Martin
P.S Still would like to know if Kevin uses ‘Dapper Dan’ all the same 😆
Re: bosch dishwasher SGS5312 – stuck on rinse mode
daveadams wrote:Is this prob a sign of impending doom?
Not at all, they are good machines…keep the faith 8)
But if it fails again you know where to come 😉
Martin
Re: Welcome To The War Room
Mark is a top man in my book and should be treated by all of us as a ‘confidant’ and a person that could bolster a strong team. If there is need to remove dead wood anywhere then he could help to propagate growth should it be required. 😉
Just keep him in mind for now then if you will 8)
Martin
