Forum Replies Created
-
Posts
-
Re: double sided tape for facia
Can’t read Don’s link but any double sided tape will suffice. Easily available at all good DIY stores. Mind you, I use the stuff carpet fitters use (much more better, sticks like hell) 😉
Re: Hotpoint Aquarius DWF30 – not starting
There is no “emergency drain” on any dishwasher. But the user instruction booklet clearly shows how access to the drain pump can be achieved as well as how to reset the cycle.
You will have to scoop out the dirty water with a cup or similar vessel first and sponge out the remainder mind you. Once done that the rest is shown clearly in that manual I referred to. I do hope that helps you? 😀
Re: Indesit Moon Model Sixl 145 UK won’t extract water
Something caught in the tub to pump hose or the pump to drain hose?
Ebac, design your own washing machine
A very exciting concept, to fight this Italian and Turkish junk head on. I wish them well. The ‘build your own’ concept with hot full and extended warranty an exciting prospect. Now we need to capture the service agency for them and this could really take off.
I have long since argued the ISE concept has chosen the wrong market place. Ebac however could come in at an affordable mass market with lots of willing independent sales/servicing agents. 💡
Re: Siemens WT46E389GB/15 Bleeps twice
Could be: Condenser door not latched, door not shut, ambient temp below 5C?
Re: Help understanding Bosch Models- WAQ283S1GB any good?
……..John Lewis, Currys, AO and others have their own ‘buyers’ that insist Bosch supply a range of machines to them each bearing a different model number. Therefore none can be cross-referenced for price comparison. The clever, long established “Never Knowingly Undersold” sales slogan ensures the product they sell therefore cannot be purchased cheaper elsewhere.
There is merit in a little sales ‘research’ but, as you have discovered, it is virtually impossible to get a true comparison as a result. As my colleague said earlier, they are pretty much the same machine anyway. 😀
Re: connect rip off merchants
You hope? Masterpart are another caution. You don’t (can’t) be sure until you order. 😉
Re: connect rip off merchants
Always beware of prices, (especially CDSL THE trade rip-off merchants). But the problem is that many, including Qualtex, will show lower prices but don’t have stock. So you’re stuffed all ways…….
Re: Hotpoint Aquarius DWF30 – not starting
Ynot wrote:Not sure how to reset the cycle……….how can I drain the machine…?
How about you :rtm: then all will be revealed including the programme ‘reset’ process. (Google DWF30 user manual)
Emergency drain covered in that manual……
Zanussi pausing mid cycle
The end light represents the first digit, the start the second. Therefore:
Error code 52 = No signal from the tacho generator, PCB faulty or motor faulty.
Re: Zanussi FLA 1001
The limescale will wash out easily enough.
Little tip : never go out or to bed leaving a washer running. Or dear me no. If it fails, floods or catches fire it can be a fatal mistake.
Re: Thread locking!
‘Twas not the conspiracy of censorship after all, unless a diabolical plot was hatched by Apple for some reason.,,,?
Perhaps the moral of the story is not to be hasty upgrading to ios8. (Word has it that it is best avoided in the first place and cannot be undone).
Don and Ken rallied round so no harm done….carry on!
