Martin

Forum Replies Created

Viewing 15 posts - 3,856 through 3,870 (of 25,534 total)
1 2 3 … 257 258 259 … 1,701 1,702 1,703
  • Author
    Posts
  • September 20, 2014 at 12:40 pm in reply to: zwt71401 #419431
    Martin
    Participant

    Re: zwt71401

    Door interlock connector plug burning out is an issue with these.

    September 20, 2014 at 12:35 pm in reply to: zanusie dead zxg 7165 #419427
    Martin
    Participant

    Re: zanusie dead zxg 7165

    What’s that model number again?

    September 20, 2014 at 12:08 pm in reply to: Washing Machine switching itself off #419424
    Martin
    Participant

    Re: Washing Machine switching itself off

    Robdog wrote:no d.r.o. nothing.

    Can you please explain what that means?

    September 20, 2014 at 10:43 am in reply to: Whirlpool AWO/D4505 stopped working after building works #419332
    Martin
    Participant

    Re: Whirlpool AWO/D4505 stopped working after building works

    You could try the pressure switch system next 💡

    September 20, 2014 at 10:41 am in reply to: awod5726 #419425
    Martin
    Participant

    Re: awod5726

    Fit a complete new wiring loom for funny money. But better still reconnect using insulated spade terminals (aka Amp Tags) 💡

    September 20, 2014 at 9:06 am in reply to: Candy cdb 264 – thermostat keeps clicking off when on dryer #419415
    Martin
    Participant

    Re: Candy cdb 264 – thermostat keeps clicking off when on dr

    If it is an early version it will need to up rated thermostat modification (part no. 41024208). The preset temp has been increased from 172C to 182C. That stops ‘nuisance tripping’. 😀

    September 20, 2014 at 8:58 am in reply to: Washing Machine switching itself off #419422
    Martin
    Participant

    Re: Washing Machine switching itself off

    Have you tried another wall socket?

    September 19, 2014 at 6:20 pm in reply to: Bosch WAE24162UK/08 #419408
    Martin
    Participant

    Re: Bosch WAE24162UK/08

    All lights flashing means the microprocessor is stuffed. Probably caused by electrical ‘spike’ during power cut. 🙁

    September 19, 2014 at 7:29 am in reply to: AEG T37320 runs for 30secs then goes to end cycle #419384
    Martin
    Participant

    Re: AEG T37320 runs for 30secs then goes to end cycle

    Martin wrote:Do any of the lights flash on the control panel? If so which ones?

    ….and the lights?

    September 18, 2014 at 8:42 pm in reply to: AEG T37320 runs for 30secs then goes to end cycle #419382
    Martin
    Participant

    Re: AEG T37320 runs for 30secs then goes to end cycle

    Stopping after a few seconds is nothing whatsoever to do with the heater, period!

    The fault is to do with the brush sensor pick-up of the drum. If the electronics do not get a reading from the brushes it simply shuts down after a few moments. So the drum sensor band and the brushes need checking. Probably just need cleaning?

    Do any of the lights flash on the control panel? If so which ones?

    September 18, 2014 at 8:32 pm in reply to: Neff S54M45X5GB/01 dishwasher fill then empty #419374
    Martin
    Participant

    Re: Neff S54M45X5GB/01 dishwasher fill then empty

    tinfish wrote:That would be the pressure chamber then?

    Not something you need to buy and fit but simply check out and clean if that is the fault…..

    September 18, 2014 at 5:44 pm in reply to: Beko tall fridge #419392
    Martin
    Participant

    Re: Beko tall fridge

    Cardboard backing? That’s odd! What’s the model number of the fridge anyway???

    September 18, 2014 at 5:14 pm in reply to: vtd00 drum scraping #419120
    Martin
    Participant

    Re: vtd00 drum scraping

    delta01 wrote:thanks v much all

    I wouldn’t mind betting this one is heading for environmental disposal. 😉

    September 18, 2014 at 5:09 pm in reply to: AEG T37320 runs for 30secs then goes to end cycle #419380
    Martin
    Participant

    Re: AEG T37320 runs for 30secs then goes to end cycle

    Can you give us the full model number (PNC no) of your appliance?

    September 18, 2014 at 5:03 pm in reply to: Neff S54M45X5GB/01 dishwasher fill then empty #419372
    Martin
    Participant

    Re: Neff S54M45X5GB/01 dishwasher fill then empty

    I think it more likely an issue with the pressure switch/transfer pipe to the tub. The banging you refer to, does that not relate to the red float switch going on and off, up and down?

  • Author
    Posts
Viewing 15 posts - 3,856 through 3,870 (of 25,534 total)
1 2 3 … 257 258 259 … 1,701 1,702 1,703