Forum Replies Created
-
Posts
-
Re: AEG 64800 AL3 not Heater Element!
Hi Andyman, the AL3 indicates that the water temp rise has not been sensed.
This could be due to the Safety Stat, broken wiring, NTC sensor or the Power Module being at fault.
pull the plug before checking please.Cheers
MartinRe: HELP BUILT IN DISHWASHER PARTS
Not sure but I think the springs may be connected to cables routed to tension adjusters at cabinet top-front. ❓
Re: Indesit wm12xuk bearing
I am fairly sure that the shaft seal is part No: C00096186
Cheers
MartinRe: Zanussi Washer/Dryer WFS1265W
Could be a problem with the cable connection between the main pcb and the display card.
Re: electra reverse action condenser dryer , help no heat
Hi Andy,
They are easy to get to, just unplug machine, remove the bulging out rear heater cover, and the stats are easily found just above the element assy.
They came as a pair and have to both be replaced.
They are available from this site, just follow this link.Re: Indesit WG1234T – prog sticking + now grinding on rotati
Swampie wrote:– how can I check for objects between the drum + outer tub – through the holes in the drum – or is there a better way?
If it sounds like something between tub/drum then I usually gain access by removing the heater but they can be a bit awkward to get back in again. 😡
Martin
Re: Indesit WG1234T – prog sticking + now grinding on rotati
Hi David,
The filling & emptying problem sounds like its syphoning. Make sure that the end of the outlet hose is not pushed too far down the waste pipe.The noise could be the bearings which are not too bad to replace on this model as the spider will come strait out the back, though the drum pulley can be difficult remove.
Also quite common is something like a bra wire lost between inner cylinder & outer tub make scraping noise – check this first!.
Cheers
MartinRe: electra reverse action condenser dryer , help no heat
Hi, This fault is usually caused by an open circuit thermostat mounted on top of the heater assy. meter them out to make sure.
part number 1701583 if required.
cheers
MartinRe: Powder drawer – Help needed!!
Hi, as far as I can remember there is no release button to press. Just open the drawer to its full extent then hold it firmly both sides and pull.
Cheers
MartinRe: comemda LF320
Hi, I have found the manufactures website which might be a good starting place.
http://www.comenda-ali.it/sito_uk/default.htmHope this helps
Martin
Re: Hoover Quattro AS110 Carbon Brushes
Hi, For a Sole motor I would try the CAR53 set from Qualtex catalogue.
I know the holders may look different but they should fit ok.
CheersRe: Zanussi DX6453 – Flashing End Light
Hi Andy, I thought these machines only flashed up 5 fault code flashes to the user. If it is 5, then it may mean the motor triac is short circuit and a new board may be required.
Re: Creda T620CW – Tumble Dryer cutting out
Hi, the relay is mounted behind the control panal near the top centre. there are about 6 terminals on it. it is the coil that goes bad and is not repairable. as Martin said, a replacement relay is the only option.
Re: When Adam was a lad!
What about the nylon straps on the ada coronation, the crap goblin twin tubs with delco brush motors each side, using boiling water to expand and release the spin can from the tapered shaft of the rolls rapide, the changing of the ocv on the burco 21, and remember the old parnall semi auto washer that used to save the hot water ready for the next load! 😯
