Forum Replies Created
-
Posts
-
Re: Zanussi ZWF 1021
Yes its the modern version,so i can do it without removing the front weight i assume?
Martin
Re: Hotpoint Aquarius FDM550 top arm not spinning
Is the sliding rack located correctly on the runners either side?
MartinRe: Kenwood Dishwasher KDW 243A/A door spring wire loop
If you look at the left hand colums the top one of second column down says “brand”
Use this to search the make/model number, then it will show parts available for that specific model and you will see a tab marked “mediator” tnis shows exploded diagrams etc….not available for everything, but very handy all the same,,Martin
MartinRe: Dyson dc04 motor
It usually means a new motor, brushes not readily available…just make sure its not the brushroll thats making the noise,or if fitted,the clutch.. But 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time its the motor…
MartinRe: hoover OPH-614/L-80 WON’T FILL
Got one to look at today with what sounds like the same problem…thanks for the info
Martin
Re: Kenwood KDW243A dishwasher
Come on guys! I know these machines are c*#p, but anyone got any pointers..
Martin
MartinRe: INDESIT IDE 1005 DISHWASHER A08 FAULT CODE
It could be that the heater thermistor has come loose,and it isn’t correctly reading the temperature of the water,so the water should be very very hot..
To get at the thermistor you will need to unplug the machine from the mains,you then need to open the door and remove the screws from each side of the inner door skin,carefully remove the outer door panel (beware it can have sharp edges) and you will see the thermistor connected by two wires and it normally is held in place by a small clip this should be in close contact with the inner door skin to work correctly..
Martin
Re: INDESIT IDE 1005 DISHWASHER A08 FAULT CODE
The code A08 relates to a heater circuit problem..is the machine heating the water?
Re: Hotpoint WMA spin speeds
It’s just a query a customer had,as he had WM50 & a WM56. 1000 & 1200 spin respectively..he said they seem to have identical boards and motors yet diff spin speeds..just got me thinking!
Martin
Re: Hotpoint aquarius + (WMF760) – f11 fault
Hmmm now thinking this may be a super silent model…motor doesent have brushes ..
Blush
MartinRe: Hotpoint aquarius + (WMF760) – f11 fault
The brushes are located in the rear of the motor, usually held in with 2 screws either side of the plastic housing.. If they are around a half inch or less then they need repalacing..
MartinRe: Bosch WF2001 pump problem
Check the impellor is not loose on its spindle, also check your waste outlet pipe is clear and your waste connection also…
Martin
