Forum Replies Created
-
Posts
-
Re: Hotpoint aquarius + (WMF760) – f11 fault
Are you sure the tacho magnet is tight,if you can turn this by hand,it can cause erratic spin and wash speeds !
Re: Bosch Classixx SGS43C12GB NOT FILLING
Id go with jims reply first, check you dont have any leaks..
Also try turning the water supply off at the tap, if the pump eventually stops, then try it again with the tap on. If it then takes water in, then you probably have a leak somewhere which is activating the pump..
MartinRe: Bosch Classixx SGS43C12GB NOT FILLING
Water inlet valve is your first thing to check ithink
Martin
MartinRe: Hotpoint wma40 washing machine not going beyond final sp
When you say stops after final spin,can you then open the door as normal?
If not it could be a blockage in the pressure vessel, and if the brushes in the motor have never been renewed,then its worth checking those out as well
Martin
Re: Hotpoint 95 series fasicas, dials and trim etc.
He’s welcome to whatever he wants,nice to see youngsters appreciating quality!
James,PM me when u can
Re: Hotpoint 95 series fasicas, dials and trim etc.
Its a 9534, totally original apart from a replacement white dial i think.?
Bit of surface rust etc but it works..
Martin
MartinRe: Hotpoint 95 series fasicas, dials and trim etc.
I,ll go check out the model number for you now…as its in the van!
MartinRe: Hotpoint 95 series fasicas, dials and trim etc.
I picked up a hotpoint suoer electronic 1000 spin model today..its a 95 series.. Its for the tip but you can have what younwant from it…apart from soap drawer, as at is missing!
Martin
MartinRe: zanussi ZWD122070W
Hi steve
Error code ED4 relates to either a problem with the dryer circuit board , or the dryer element..
Before you proceed further make sure you remove all power to the machine by unplugging.You can then remove the top, and you will see the dryer unit that contains the heater mounted jn a metal unit.. You will see the element connections sticking out from the rear of this unit,you need to remove these wires only! Make a note of what colour goes to what connections (easist way is to take a photo withyour mobile phone cam.
Then insulate the wires with tape,and try the machine again… If it works then you need to repalce the heaters..if t doesent it usually points to the dryer PCB or associated wiring..
Martin
MartinRe: Zanussi 1265 washer dryer leak
Check the bottom of the door seal,pull out the folds and you may find a hole there
Martin
Re: Candy CC217-80 scraping noise
The scraping noise you refer to is more than likely the rear bearing..
Power off before proceeding!
If you look at the rear of the machine inline with the centre if the drum, there should be a cover over the bearing assembly, remove this and check for any signs of a black dust,and check the position of the shaft.
You will probably find that the shadt has worn its way through the bearing and is now resting on the metal bearing housing, or worse still the machine casing…not to difficult a job to replace…
Martin
