Forum Replies Created
-
Posts
-
Re: Hotpoint TDC62
Thanks for the prompt reply, iadom
I’ll give it a go.. Sounds easy enough though
Martin
Re: Indesit WIXE 127
Update
Went to see this machine. Had f05 fault showing. Checked usual culprits.. Then lastly I checked the under sink connector from the machine.. There was a 1p coin wedged perfectly inside stopping all flow off water!
Strange thing is that the coin could not have come from the machine as the diameter of connector was slightly to small…. And doubt it could have been forced up from the other side of connector as the sink waste outlet has very small holes .. So the coin could not have come from the sink
So,still baffling , but one to watch out for
Martin
Re: Unknown dishwasher
Won’t be goin to see it for a week or so, so am unable to get dimensions of element..
He now says it trips as soon as its switched on! So maybe it’s the mains suppressor at fault?Martin
Re: Indesit G74c tumble dryer
Not familiar with the location of it on this model, but it’s usually located on the motor itself ( a white cylindrical plastic item ) usually has 2 or 4 wires attached.. If you are replacing yourself. Make sure the dryer is unplugged before you do anything .. And make a detailed note of the wiring
hopefully another trade member can supply you with the correct part
Martin
Re: hotpoint WDD960 F11
My own WDD960 just gone the same way, last time it went,it was down to a loose main PCB connector…
Although this time it won’t do the spin on any programme…
Any ideas greatly appreciated… Tho I think it’s time for a new board from EMWMartin
Any vacuum cleaner experts???
Hi tony
It’s usually just the small foot switch release that breaks on these, although I have had a few where the motor retaining bands have snapped away from the chassis base… If you find the handle moves from side to side more than is normal… It’s BER!
Hope this helps
Martin
Hotpoint 9510 & 9530
Yes JIm, excellent information in those manuals..more than I expected.
Very much appreciated
Martin
Oven facia lettering being removed easily
Why don’t the makers, just sandwich the lettering Inside the glass/ plastic fascias
Then in theory it should last the lifetime of the appliance….
Though I guess there are some that already do ?Muv
Hoover Junior age
Hi Madrat
The closest dates fo each Hoover is as follows
1134 — 1967
1334 — 1958
1346 — 1967
U1104 — 1985
Hope this helps
Martin
